Whirlpool 2183013 Kullanım ve Bakım Kılavuzu - Sayfa 11
Buzdolabı Whirlpool 2183013 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Whirlpool 2183013 24 sayfaları. Whirlpool refrigerator 2183013 use and care guide
![Whirlpool 2183013 Kullanım ve Bakım Kılavuzu](/uploads/products/server2/6803356/6803356.png)
Solving
common
ice maker
problems
PROBLEM
POSSIBLE CAUSE/SOLUTION
ice crescents
attached
l
This is normal. They break apart easily. Shake bin
at corners
occasionally to keep cubes separated.
ice maker will not
l
ON/OFF lever is in the OFF (up) position. Lower lever to the
operate or ice is not
ON (down) position.
made fast enough
l
Freezer is not cold enough. Adjust temperature control and
wait 24 hours.
Off-taste
or odor in ice
l
New plumbing connections can cause discolored or off-
flavored ice. Discard the first few batches of ice.
l
Cubes are stored too long. Throw them away and make a
new supply.
l
Foods in freezer are not wrapped properly. See "Food
Storage Guide" on pages 20 and 21.
l
Freezer and ice bin need to be cleaned. See page 16.
Attaching
the ice maker
to a water
supply
Read all directions
carefully
before
you begin.
Electrical
Shock Hazard
Disconnect electrical supply to refrig-
erator before installing.
Electrical drill must be grounded before
drilling holes in water line.
Failure to do so could result in death,
electrical shock, or serious injury.
IMPORTANT:
l
Use copper tubing only and check for leaks.
l
Install ice maker tubing in areas where
temperatures are above freezing.
Tools
required:
l
Standard screwdriver
l
'As-inch and X-inch open-end wrenches or
2 adjustable wrenches
l
%-inch nut driver
l
%-inch drill bit
l
Hand drill or electric drill (properly grounded)
NOTE:
Your appliance dealer has a kit
available with a X-inch saddle type shut-off
valve, a union, and copper tubing.
Before purchasing, make sure a saddle type
valve complies with your local plumbing
codes. Do not use piercing type or %-inch
saddle valve which reduces water flow and
clogs more easily.
Cold water
supply
Ice maker water valve contains a flow
washer which is used as a water pressure
regulator. The ice maker needs to be
connected to a cold water line with water
pressure limitations of 20-120 PSI. If a
problem occurs, call your utility company.
IMPORTANT:
l
It may take up to 24 hours for your ice
maker to begin producing ice.
l
If operating the refrigerator before install-
ing the water connection, turn ice maker to
the OFF position to prevent operation
without water.
l
All installations must be in accordance with
local plumbing code requirements.
INSTALLATION
IS NOT WARRANTED