Whirlpool 2199011 Buzdolabı Kullanım ve Bakım Kılavuzu - Sayfa 6
Buzdolabı Whirlpool 2199011 için çevrimiçi göz atın veya pdf Buzdolabı Kullanım ve Bakım Kılavuzu indirin. Whirlpool 2199011 43 sayfaları. Whirlpool top-mount refrigerator use&careguide 2199011
Sayfayı YazdırElectrical Requirements
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical
connection:
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused,
grounded electrical supply is required. It is recommended
that a separate circuit serving only your refrigerator be
provided. Use an outlet that cannot be turned off by a
switch. Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning,
or removing a light bulb, turn the Thermostat Control (or
Refrigerator Control depending on the model) to OFF and
then disconnect the refrigerator from the electrical source.
When you are finished, reconnect the refrigerator to the
electrical source and reset the Thermostat Control (or
Refrigerator Control) to the desired setting.
6
Connecting the Refrigerator
to a Water Source
Read all directions carefully before you begin.
IMPORTANT:
If operating the refrigerator before installing the water
connection, turn ice maker to the OFF position to
prevent operation without water.
All installations must be in accordance with local
plumbing code requirements.
Use copper tubing and check for leaks.
Install copper tubing only in areas where temperatures
will remain above freezing.
It may take up to 24 hours for your ice maker to begin
producing ice.
Tools required:
Standard screwdriver
-inch and
-inch open-end wrenches or two
adjustable wrenches
-inch nut driver
-inch drill bit
Hand drill or electric drill (properly grounded)
NOTE: Your refrigerator dealer has a kit available with a
-inch saddle-type shut-off valve, a union, and copper
tubing. Before purchasing, make sure a saddle-type valve
complies with your local plumbing codes. Do not use a
piercing-type or
-inch saddle valve which reduces water
flow and clogs more easily.
Cold Water Supply
The ice maker water valve contains a flow washer which is
used as a water pressure regulator. The ice maker needs to
be connected to a cold water line with water pressure
between 30 and 120 psi. If a problem occurs, call your
utility company.
Connecting to water line:
1. Unplug refrigerator or disconnect power.
2. Turn OFF main water supply. Turn ON nearest faucet
long enough to clear line of water.