Whirlpool 2318493 Kullanım ve Bakım Kılavuzu - Sayfa 8

Buzdolabı Whirlpool 2318493 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Whirlpool 2318493 36 sayfaları. Whirlpool ec3jhaxrs: user guide

Sayfayı Yazdır

The ice maker is not producing ice or not enough ice

Is the ice maker wire shutoff arm or switch (depending on

models) in the OFF position?

Is the water line shutoff valve to the refrigerator turned on?

Has the ice maker just been installed? Is the freezer

temperature cold enough to produce ice? Wait 24 hours

after ice maker hookup for ice production to begin. Allow

3 days after ice production begins to completely fill ice

container.

Does the ice maker mold have water in it or has no ice

been produced? Make sure your refrigerator has been

connected to a water supply and the supply shutoff valve is

turned on.

Has a large amount of ice just been removed? Allow

24 hours for ice maker to produce more ice.

Is there a water filter installed on the refrigerator? The filter

may be clogged or installed incorrectly.

Is an ice cube jammed in the ice maker ejector arm?

For models with an interior ice bin, remove the ice from the

ejector arm with a plastic utensil.

Is a reverse osmosis water filtration system connected to

your cold water supply? See "Water Supply Requirements"

in either the Installation Instruction booklet or the Use & Care

Guide.

The ice cubes are hollow or small

This is an indication of low water pressure.

Check the following:

Is the water shutoff valve fully open?

Are there kinks in the water lines that could restrict water

flow?

If you are using a water filter, remove the filter and operate the

dispenser. If water flow increases, the filter is clogged or

incorrectly installed.

Is a reverse osmosis water filtration system connected to

your cold water supply? See "Water Supply Requirements"

in either the Installation Instructions or the Use & Care Guide.

If you still have questions regarding your water pressure, call a

licensed, qualified plumber.

Off-taste, odor or gray color in the ice

Check the following:

Are the plumbing connections new, causing discolored or off-

flavored ice?

Have the ice cubes been stored too long?

Does the freezer and ice bin need to be cleaned?

Has food in the freezer or refrigerator been wrapped properly?

Does the water contain minerals (such as sulfur)? A filter

may need to be installed to remove the minerals.

Is there a water filter installed on the refrigerator? Gray or

dark discoloration in ice indicates that the water filtration

system needs additional flushing.

Ice and Water

The ice dispenser will not operate properly

If the ice storage bin is located on the door, remove the temporary

shield from underneath the ice storage bin. See "Ice Maker and

Storage Bin."

Check the following:

Is the freezer door closed completely?

Is the ice bin installed correctly?

Is there ice in the bin?

Has the ice frozen in the ice bin?

Is ice stuck in the delivery chute?

Has the wrong ice been added to the bin? Use only cubes

produced by the current ice maker.

Has the ice melted around the auger (metal spiral) in the

ice bin? Dump the ice cubes and clean the ice bin. See "Ice

Maker and Storage Bin."

Use a sturdy glass when dispensing ice.

Failure to do so can result in cuts.

Is the ice dispenser stalling while dispensing "crushed"

ice? Change the ice button from "crushed" to "cubed." If

cubed ice dispenses correctly, depress the button for

"crushed" ice and begin dispensing again.

Has the dispenser lever been held in too long? Ice will stop

dispensing when the arm is held in too long. Wait 3 minutes

for dispenser motor to reset before using again.

The water dispenser will not operate properly

Check the following:

Is the freezer door closed completely?

Is the water shutoff valve not turned on, incorrectly installed or

clogged?

Is the water line connected at the source?

Is there a kink in the home water source line?

Has the water system not filled? The water system needs to

be filled the first time it is used.

Is the refrigerator connected to a cold water line with

water pressure of at least 30 psi (207 kPa)? The water

pressure to the home determines the flow from the dispenser.

Is there a water filter installed on the refrigerator? The filter

may be clogged or incorrectly installed.

Is a reverse osmosis water filtration system connected to

your cold water supply? See "Water Supply Requirements"

in either the Installation Instructions or the Use & Care Guide.

WARNING

Cut Hazard