Ariston TCF 87B Talimat Kitapçığı - Sayfa 15

Kurutucu Ariston TCF 87B için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Ariston TCF 87B 17 sayfaları.

Sayfayı Yazdır

19510300500_AUS

English, All Logos to be Ariston

Maintenance and Care

Switching off the electricity

! Unplug the dryer when not using it, when cleaning it,

and during maintenance activities.

Clean the filter after each cycle

The filter is an important part of your dryer: it

accumulates lint and fluff that is formed while drying.

When finished drying, clean the filter by rinsing it under

running water or with your vacuum cleaner. Should the

filter become clogged up, the airflow inside the dryer will

be seriously compromised: drying times lengthen and

you will consume more energy. It may also damage

your dryer.

The filter is found in front of the dryer trim (see

into the tumble dryer trim.

Remove any lint that has built up on the inside of

the door and around the door seal.

! Do not use dryer without replacing the filter.

Check the drum after each cycle

Turn the drum manually in order to remove small items

(handkerchiefs) that could have been left behind.

Cleaning the drum

! Do not use abrasives, steel wool or stainless steel

cleaning agents to clean the drum

A coloured film may start to appear on the stainless steel

drum, this may be caused by a combination of water and,

or cleaning agents such as fabric conditioner from the

wash. This coloured film will not affect the dryer

performance.

diagram).

Pull the plastic grip of the filter

upwards (see diagram).

Open the filter and clean

the lint from the inside

Replace it correctly.

Ensure the filter is fully located flush

{PDF Created 18/01/13 22:28:00}

Empty the Water Container after each

cycle

Pull the container out of the dryer remove either the small

or large cap and empty it into a sink or other suitable

drain. Refit the cap to the bottle and replace the container

securely.

Always check and empty the container before you start a

new drying programme.

Cleaning the Condenser Unit

• Periodically (every month) remove Condenser unit and

clean any build up of fluff from between the plates by

rinsing it under the tap with cold water. This should be

done with cold water from the rear of the condenser.

To remove condenser

Unplug the dryer and open the door.

Pull open the condenser cover (see diagram),

release the three catches by turning 90° counter

clockwise then pull on the grip and remove from

dryer.

Clean the surface of the seals and replace with the

arrows pointing upwards making sure that the

catches have been secured.

Cleaning the dryer

• External parts in metal or plastic and rubber parts can

be cleaned with a damp cloth.

• Periodically (every 6 months) vacuum the front Air

intake grille, to remove any build up of fluff, lint or dust.

Also to remove accumulation of fluff from the front of

condenser and filter areas, clean occasionally with a

vacuum cleaner

! Do not use solvents or abrasives.

! Your dryer uses special bearing components which

do not need lubrication.

! Have your dryer checked regularly by authorized

technicians to ensure electrical and mechanical safety

(see Service).

TD4207FUL Issue 3