Whirlpool WRX-17TM Servis Kılavuzu - Sayfa 20

Buzdolabı Whirlpool WRX-17TM için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Whirlpool WRX-17TM 27 sayfaları. Silver color, electronic no frost refrigerator dual fan, maestro project, high range smile design

Sayfayı Yazdır

6. Remove the fan motor

7. Remove the Membrane details.

Note: This membrane has the function of avoiding the air re-flow (return) and must not be removed under any

circumstances.

8. When reassembling the set redo the air Duct sealing.

Important: Never remove the seals located at the rear of the air diffuser. Should they be damaged during

disassembly, replace them with new ones, which are available as spare parts.

Without them, the flow of cold air will cause frost in some areas or even an increase in refrigerator temperature

(in the event of air directly leaking onto the Refrigerator Sensor).

Redo the insulation of the cut portion, using a tape of the type "silver tape" or either of the tapes below:

Euro ST400 Tape - Sicad do Brasil;

465G Tecroll Tape - Milano Técnica;

Scotch 56 Polyester Tape - 3M do Brasil.

Do not use krepp tape (packing tape) or electrical tape (black tape) to redo the seals.

7.5. Evaporator

WARNING: Be careful when handling the Evaporator, due to it blades has sharp edges and can cut your hands.

Always wear protective gloves.

1. Order a new evaporator assy and 2 Lokring connectors, according spare parts list.

Note: The Evaporator assy include chute and defrost heater which should be replaced simultaneously due to

the possibility of defrost heater damage while removing from the old evaporator, causing electrical escape.

2. Remove the damaged evaporator by releasing the Heater connectors, EPS shims, Lokring connectors and

then the tabs that support it located in the cabinet liner.