Whirlpool YET17JKYJW00 Kullanım ve Bakım Kılavuzu - Sayfa 6

Buzdolabı Whirlpool YET17JKYJW00 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Whirlpool YET17JKYJW00 36 sayfaları. Top-mount refrigerator

Sayfayı Yazdır

Using a grounded drill, drill a 1/4in. (6.35 mm) hole in the cold

Style 1

water pipe you have selected.

...... •........

7 ._

................

1. Cold Water Pipe

2. Pipe Clamp

3. Copper Tubing

4. Compression

Nut

5. Compression

Sleeve

6. Shut-Off Valve

7. Packing Nut

6. Fasten shut-off valve to cold water pipe with pipe clamp. Be

sure outlet end is solidly in the 1/4in. (6.35 mm) drilled hole in

the water pipe and that washer is under the pipe clamp.

Tighten packing nut. Tighten the pipe clamp screws carefully

and evenly so washer makes a watertight seal. Do not

overtighten

or you may crush the copper tubing, especially if

soft (coiled) copper tubing is used. Now you are ready to

connect the copper tubing•

7. Slip compression

sleeve and compression

nut on copper

tubing as shown. Insert end of tubing into outlet end squarely

as far as it will go. Screw compression

nut onto outlet end

with adjustable wrench. Do not overtighten.

8. Place the free end of the tubing into a container or sink, and

turn ON main water supply and flush out tubing until water is

clear• Turn OFF shut-off valve on the water pipe. Coil copper

tubing.

Connecting

to refrigerator:

NOTE: The first step for connecting the water line to your

refrigerator is different depending on the type of water valve

provided with your refrigerator• See the diagrams below to

determine the style of valve you have. (On kit models, assemble

water valve to refrigerator per kit instructions.)

1. For Style 1, disconnect

the tube clamp on the back of the

product and insert the copper tubing through the clamp, as

shown. Remove the tape label from the valve inlet and insert

copper tubing until it bottoms out (approximately

¾ in. [1.9

cm]). Tighten nut by hand as much as possible; then turn the

nut an additional 1/2 turn using a wrench• Do not overtighten.

Re-attach the tube clamp and tube to the back of the cabinet.

Skip to Step 2.

For Style 2, disconnect

the tube clamp on the back of the

product and insert copper tubing through the clamp as

shown. Attach the copper tube to the valve inlet using a

compression

nut and sleeve as shown. Tighten the

compression

nut. Do not overtighten. Re-attach the tube

clamp and tube to the back of the cabinet• Move to Step 2.

2. Turn shut-off valve ON. Check For Leaks. Tighten any

connections

(including connections at the valve) or nuts that

leak.

Style 2

1. Tube Clamp

2. Copper Tubing

3. Compression

Nut

4. Valve Inlet

1. Tube Clamp

2. Copper Tubing

3. Compression

Nut

3. The ice maker is equipped with a built-in water strainer. If

local water conditions

require periodic cleaning or a well is

your source of water supply, a second water strainer should

be installed in the 1/4in. (6.35 mm) water line. Obtain a water

strainer from your nearest appliance dealer. Install at either

tube connection.

4. Plug in refrigerator or reconnect power•