Fireplace K1266 Manuel - Sayfa 13

Soba Fireplace K1266 için çevrimiçi göz atın veya pdf Manuel indirin. Fireplace K1266 19 sayfaları.

14. Further use:

If you have already used the stove, remove the ash from the combustion cham-

ber before lighting another fire.

Always empty the ash drawer before each use, while the unit and the ashes are

cold, because a full ash drawer can

obstruct air supply

damage the grate

After emptying the ash drawer, replace it immediately.

Continue the lighting procedure according to the section "Lighting the fire for

the first time".

Load more fuel only if the current fuel is only glowing and flames are not visi-

ble any more. When loading more fuel, open the door of the combustion cham-

ber slowly so that the smoke gases cannot flow out through the door. Level the

glowing embers. Put the amount of fuel necessary for the desired heating

capacity on the embers, leaving an inch of space between each piece. Close

the door immediately after loading the fuel and keep it closed during use.

Set the air regulators according to the nominal capacity, or in case of brown

coal briquettes as desired after it has burned down to embers. Always maintain

optimal burning!

Repeat the procedure after the fuel has burned down.

Never put more fuel in the stove at one time than is specified. (See Technical

data sheet)

Only one portion of fuel can be burned at the same time. Load more fuel, only

the fuel in the unit already, has burned down.

Always check that there are not too many glowing embers piling up in the com-

bustion chamber.

Do not restrain the fire, load less fuel instead, and never close the primary air

regulator completely.

Your stove is equipped with an automatically closing door. It can be operated

only with a closed door.

Open the door only if you want to load more fuel and only if the previous amount

has burned down to embers.