Whirlpool  WED9051YW Kurulum Talimatları Kılavuzu - Sayfa 13

Kurutucu Whirlpool  WED9051YW için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Whirlpool  WED9051YW 20 sayfaları. Installation guide
Ayrıca Whirlpool  WED9051YW için: Kullanım ve Bakım Kılavuzu (20 sayfalar)

Sayfayı Yazdır
4.
Connect neutral wire
Place hooked end of neutral wire (white or center) (C) of direct
wire cable under center terminal block screw (B). Squeeze
hooked end together. Tighten screw.
5.
Connect remaining wires
Place hooked ends of remaining direct wire cable wires under
outer terminal block screws (hooks facing right). Squeeze
hooked ends together and tighten screws. Finally, reinsert tab
of terminal block cover into slot of dryer rear panel. Secure
cover with hold-down screw. Now, go to "Venting Requirements."
OPTIONAL EXTERNAL GROUND
FOR 3-WIRE CONNECTION
You must verify with a qualified electrician that this
grounding method is acceptable before connecting.
1.
Prepare to connect neutral ground
wire and neutral wire
Remove center terminal block screw (B). Remove neutral
ground wire (E) from external ground conductor screw (A).
2.
Connect neutral ground wire and
neutral wire
B
C
Connect neutral ground wire (E) and neutral wire (white or
center wire) (C) of power supply cord or cable under center
terminal block screw (B). Tighten screw.
3.
Connect remaining wires
Place hooked ends of remaining wires under outer terminal
block screws (hooks facing right). Tighten screws.
4.
Connect external ground wire
A
G
E
B
Connect a separate copper ground wire (G) from the external
ground conductor screw (A) to an adequate ground. Finally,
reinsert tab of terminal block cover into slot of dryer rear panel.
A
Secure cover with hold-down screw. Now, go to "Venting
Requirements."
B
E
C
13