Whirlpool WED9051YW Kurulum Talimatları Kılavuzu - Sayfa 7

Kurutucu Whirlpool WED9051YW için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Whirlpool WED9051YW 20 sayfaları. Installation guide
Ayrıca Whirlpool WED9051YW için: Kullanım ve Bakım Kılavuzu (20 sayfalar)

Sayfayı Yazdır

If your outlet looks like this:

Then choose a 4-wire power supply cord with

ring or spade terminals and UL listed strain

relief. The 4-wire power supply cord, at least

4 ft. (1.22 m) long, must have 4 10-gauge solid

copper wires and match a 4-wire receptacle of

NEMA Type 14-30 R. The ground wire (ground

4-wire

conductor) may be either green or bare. The

receptacle

neutral conductor must be identified by a

(14-30R)

white cover.

If your outlet looks like this:

Then choose a 3-wire power supply cord with

ring or spade terminals and UL listed strain

relief. The 3-wire power supply cord, at least

4 ft. (1.22 m) long, must have 3 10-gauge solid

copper wires and match a 3-wire receptacle of

NEMA Type 10-30R.

3-wire

receptacle

(10-30R)

If connecting by direct wire:

Power supply cable must match power supply (4-wire or 3-wire)

and be:

Flexible armored cable or nonmetallic sheathed copper cable

■

(with ground wire), covered with flexible metallic conduit. All

current-carrying wires must be insulated.

10-gauge solid copper wire (do not use aluminum) at least

■

5 ft. (1.52 m) long.

GROUNDING INSTRUCTIONS

For a grounded, cord-connected dryer:

This dryer must be grounded. In the event of malfunction or

breakdown, grounding will reduce the risk of electric shock

by providing a path of least resistance for electric current.

This dryer is equipped with a cord having an equipment-

grounding conductor and a grounding plug. The plug must

be plugged into an appropriate outlet that is properly

installed and grounded in accordance with all local codes

and ordinances.

WARNING:

Improper connection of the equipment-

grounding conductor can result in a risk of electric shock.

Check with a quali ed electrician or service representative

or personnel if you are in doubt as to whether the dryer is

properly grounded. Do not modify the plug provided with

the dryer: if it will not t the outlet, have a proper outlet

installed by a quali ed electrician.

SAVE THESE INSTRUCTIONS

INSTALL LEVELING LEGS

Prepare dryer for leveling legs

To avoid damaging floor, use a large flat piece of cardboard

from dryer carton; place under entire back edge of dryer.

Firmly grasp dryer body (not console panel) and gently lay

dryer down on cardboard.

Screw in leveling legs

diamond

marking

Examine leveling legs, find diamond marking. Screw legs into

leg holes by hand—use a wrench to finish turning legs until

diamond marking is no longer visible.

Now stand the dryer on its feet. Slide the dryer until it is

close to its final location. Leave enough room for electrical

connection and to connect the exhaust vent.