Whirlpool 27' Kurulum Talimatları Kılavuzu - Sayfa 12

Kurutucu Whirlpool 27' için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Whirlpool 27' 27 sayfaları. Microwave oven and thermal oven
Ayrıca Whirlpool 27' için: İş Yardımı (36 sayfalar), Kurulum Talimatları Kılavuzu (11 sayfalar), Kurulum Talimatları Kılavuzu (11 sayfalar), Kurulum Talimatları Kılavuzu (48 sayfalar), Kurulum Talimatları Kılavuzu (22 sayfalar), Kurulum Talimatları Kılavuzu (32 sayfalar), Kurulum Talimatları Kılavuzu (12 sayfalar), Kurulum Talimatları (5 sayfalar)

Power Supply Cord Connection

Power Supply Cord Strain Relief

Attach power supply cord strain

relief

Remove the screws from a 3/4" (19 mm) UL-listed strain relief

(UL marking on strain relief). Put the tabs of the two clamp

sections (C) into the hole below the terminal block opening

(B) so that one tab is pointing up (A) and the other is pointing

down (D), and hold in place. Tighten strain relief screws just

enough to hold the two clamp sections (C) together.

Attach power supply cord

to strain relief

Put power supply cord through the strain relief. Be sure that

the wire insulation on the power supply cord is inside the

strain relief. The strain relief should have a tight fit with the

dryer cabinet and be in a horizontal position. Do not further

tighten strain relief screws at this point.

If your outlet looks like this:

Power supply cord 4-wire receptacle

(NEMA Type 14-30R):

Go to "4-Wire Power Supply Cord

Connection" on this page.

Power supply cord 3-wire receptacle

(NEMA Type 10-30R):

Go to "3-Wire Power Supply Cord

Connection" on page 13.

4-Wire Power Supply Cord Connection

IMPORTANT:

homes and where local codes do not permit the use of 3-wire

connections.

4-wire receptacle

(NEMA type 14-30R)

Spade terminals with

upturned ends

Prepare to connect neutral

ground wire and neutral wire.

Remove center terminal block screw (B). Remove neutral

ground wire (E) from external ground conductor screw (A).

Connect neutral ground wire

and neutral wire

Connect neutral ground wire (E) and neutral wire (white or

center) (C) of power supply cord under center terminal block

screw (B). Tighten screw.

A 4-wire connection is required for mobile

4-prong plug

Ring terminals