Whirlpool 3401083 Kullanım ve Bakım Kılavuzu - Sayfa 13
Kurutucu Whirlpool 3401083 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Whirlpool 3401083 25 sayfaları. Electric and gas dryers
Sayfayı Yazdır
Caring
for Your Dryer
Proper care of your dryer can extend its life. This section explains how to care for your dryer
properly and safely.
Cleaning
the lint screen
Every
load cleaning
The lint screen is located under a lid on top
of the dryer.
Clean it before each load. A
screen blocked by lint can increase drying
time.
To clean:
1.
2.
3.
Open the lid and pull the lint
screen straight out.
As needed
cleaning
Laundry detergents
and
fabric softeners can
cause a residue buildup on the lint screen.
Clean the lint screen with a nylon brush
every six months or more frequently
if it
becomes clogged due to a residue buildup.
Use the following method:
1.
2.
3.
4.
Roll lint off the screen with
your fingers. Do not rinse or
wash screen to remove lint.
Wet lint is hard to remove.
Push the lint screen firmly back into place
and close the lid.
IMPORTANT:
l
Do not run the dryer with the lint screen
loose, damaged, blocked or missing.
Doing so can cause overheating
and
damage to both the dryer and fabrics.
l
Some towels made of synthetic fibers and
natural fibers (polyester and cotton blends)
may shed more lint than other towels,
causing your dryers lint screen to fill up
faster. Be sure to remove lint from the lint
screen before and after drying new towels.
Wet both sides of lint screen with hot
water.
Wet a nylon brush with hot
water and
liquid detergent;
scrub lint screen
with the
brush to
remove
residue
buildup.
Rinse screen with hot water.
Thoroughly
dry lint screen with a clean
towel; replace in dryer.
Lint signal
(on some
models)
The lint signal (a whistle tone)
indicates
excessive
lint
is
present on your lint screen. A
full lint screen restricts airflow
and reduces drying efficiency.
When you hear the signal, stop the dryer
and clean the lint screen.
NOTE:
Clean your lint screen before each
load. Do not wait for the lint signal.
13