Whirlpool 3XWGD5705SW0 Kullanım ve Bakım Kılavuzu - Sayfa 10
Kurutucu Whirlpool 3XWGD5705SW0 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Whirlpool 3XWGD5705SW0 40 sayfaları. Electric and gas dryer
Drying Rack (optional)
The drying rack is useful for machine drying items you would not
necessarily want to tumble dry or that you would normally line dry
(for example, tennis shoes, pillows, stuffed toys).
If your model does not have a drying rack, you can order one by
contacting the dealer from whom you purchased your dryer.
To use the drying rack
1. Slide rear pegs into the dimples on the back wall of the dryer.
Lower the front legs to rest on the dryer opening.
2. Put the wet items on top of the rack. Leave space between
the items so air can reach all the surfaces. Close the door.
NOTE: Do not allow items to hang over the edge of the rack.
3. Select cycle and temperature to match the fabrics in your
load. Items containing foam, rubber or plastic must be dried
on a clothesline or by using an air cycle. Refer to the following
table.
4. Press START. Reset cycle to complete drying, if needed.
NOTE: The rack must be removed for normal tumbling. Do not
use the automatic cycle with the drying rack.
Rack Dry
Wool Sweaters
Block to shape and lay flat on
the rack
Stuffed toys or pillows
Cotton or polyester fiber filled
Stuffed toys or pillows
Foam rubber filled
Sneakers or canvas shoes
*(Minutes). Reset cycle to complete drying if needed.
10
Cycle
Temp
Time*
Timed
Low
60
Timed
Low
60
Air
None
90
(no heat)
Air
None
90
(no heat)
DRYER CARE
Cleaning the Dryer Location
Keep dryer area clear and free from items that would obstruct the
flow of combustion and ventilation air.
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 46 cm (18 inches) above the floor
for a garage installation.
Failure to do so can result in death, explosion,
or fire.
Cleaning the Lint Screen
Every load cleaning
The lint screen is located in the door of the dryer. Clean the lint
screen before each load. A screen blocked by lint can increase
drying time.
To clean
1. Pull the lint screen toward you. Roll lint off the screen with
your fingers. Do not rinse or wash screen to remove lint. Wet
lint is hard to remove.
2. Push the lint screen firmly back into place.
IMPORTANT:
Do not run the dryer with the lint screen loose, damaged,
blocked, or missing. Doing so can cause overheating and
damage to both the dryer and fabrics.
If lint falls off the screen into the dryer during removal, check
the exhaust hood and remove the lint. See "Checking Your
Vent."
As needed cleaning
Laundry detergent and fabric softener residue can build up on the
lint screen. This buildup can cause longer drying times for your
clothes, or cause the dryer to stop before your load is completely
dry. The screen is probably clogged if lint falls off the screen.
Clean the lint screen with a nylon brush every 6 months, or more
frequently if it becomes clogged due to a residue buildup.