Whirlpool 4GWED5500 Kullanım ve Bakım Kılavuzu - Sayfa 10
Kurutucu Whirlpool 4GWED5500 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Whirlpool 4GWED5500 48 sayfaları.
Vacation, storage, and moving care
Non-Use or Storage Care
Operate your dryer only when you are at home. If you will
be on vacation or not using your dryer for an extended
period of time, you should:
1. Unplug dryer or disconnect power.
2. Clean lint screen. See "Cleaning the Lint Screen."
Moving Care
For power supply cord-connected dryers:
1. Unplug the power supply cord.
2. Make sure leveling legs are secure in dryer base.
3. Use tape to secure dryer door.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
For direct-wired dryers:
1. Disconnect power.
2. Disconnect wiring.
3. Make sure leveling legs are secure in dryer base.
4. Use tape to secure dryer door.
Reinstalling the dryer
Follow the "Installation Instructions" to locate, level,
and connect the dryer.
10
Changing the Automatic Cycle
Settings to increase drying time
If all your loads on all Automatic Cycles are consistently
not as dry as you would like, you may change the default
settings to increase the default dryness level.
Your automatic drying settings can be adjusted to adapt to
different installations, environmental conditions, or personal
preference. This change is retained and will affect all of your
Automatic Cycles, not just the current cycle/load. There
are 3 drying settings, which are displayed using the Cycle
Status light (Wet, Damp, Cool Down LEDs):
1. Factory preset dryness level.
2. Slightly drier clothes, 15% more drying time.
3. Much drier clothes, 30% more drying time.
To change the drying settings:
NOTE: The settings cannot be changed while the dryer is
running or paused. The dryer must be in Standby mode
(the power button is off) to adjust the default settings.
1. Before starting a cycle, press and hold the TEMP button
for 6 seconds.
2. Press the TEMP button to select the dryness level
shown in the cycle status light display: Wet light
on = level 1, Wet and Damp lights on = level 2, and
Wet, Damp, and Cool Down lights on = level 3.
3. Press START/PAUSE to save the new dryness
level setting.