Whirlpool 7MWED2140 Kurulum Talimatları Kılavuzu - Sayfa 27
Kurutucu Whirlpool 7MWED2140 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Whirlpool 7MWED2140 44 sayfaları. Electric/gas dryer
Ayrıca Whirlpool 7MWED2140 için: Kullanım ve Bakım Kılavuzu (32 sayfalar)
Sayfayı Yazdır
Installation Requirements
Tools and Parts
Gather required tools and parts before starting installation.
Tools needed:
Flat-blade screwdriver
Wire stripper
1/4" nut driver
(recommended)
Adjustable wrench that
opens to 1" or hex-head
socket wrench
Ruler or measuring tape
Level
Putty knife
#2 Phillips screwdriver
Tin snips (new vent
installations)
Vent Clamps
Utility knife
Pliers
Caulking gun and compound
(for installing new exhaust vent)
Tools needed for gas installations:
8" or 10" pipe wrench
Pipe-joint compound
resistant to propane gas
Parts supplied:
Leveling legs (4)
Parts package is located in dryer drum. Check that all parts are
included.
Parts needed:
Check local codes. Check existing electrical supply and venting,
and read "Electrical Requirements" and "Venting Requirements"
before purchasing parts.
Check code requirements. Some codes limit, or do not permit,
installing dryer in garages, closets, mobile homes, or sleeping
quarters. Contact your local building inspector.
Mobile home installations require metal exhaust system
hardware, available for purchase from the dealer from whom you
purchased your dryer. For further information, please refer the
"Assistance or Service" section of the "Use and Care Guide".
If using a power supply cord:
Use a UL listed power supply cord kit marked for use with
clothes dryers. The kit should contain:
■ UL listed 30 A power supply cord, rated 120/240 V minimum.
The cord should be type SRD or SRDT and be at least
4 ft. (1.22 m) long. The wires that connect to the dryer must
end in ring terminals or spade terminals with upturned ends.
■ A UL listed strain relief.
Optional Equipment:
(Not supplied with dryer)
Refer to your "Use and Care Guide" for information about
accessories available for your dryer.
8" or 10" adjustable wrench
(for gas connections)
27