Whirlpool 8528095 Kurulum Talimatları Kılavuzu - Sayfa 10
Kurutucu Whirlpool 8528095 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Whirlpool 8528095 28 sayfaları. Electric dryer
Sayfayı Yazdır
Check Operation
1. Check that you:
did not skip any steps.
installed all parts.
properly installed dryer legs.
leveled dryer.
have secured all exhaust vent joints with 100 mm (4")
clamps.
have all the tools you started with.
2. Plug power supply cord into earthed outlet or connect direct
wire to power supply. Turn power supply on.
3. Read the Use and Care Guide to fully understand your new
dryer. Select a full heat cycle (not the air cycle) and start
dryer. After five minutes, open dryer door. You should feel
heat inside dryer.
If dryer does not operate properly, check the following:
electrical supply is connected.
house fuse is intact and tight; or circuit breaker has not
tripped.
dryer door is closed.
controls are set in a running or "On" position.
start button has been pushed firmly.
If dryer makes an unusual noise, check that the dryer is level.
Technical Specification
(see rating plate in door opening for full model details)
220-240V ~ 50 Hz, 1ph
3100W, IPX4
Clothes capacity: 9.1 kg max.
10
Moving dryer to a new location?
Check with a licensed electrician to confirm that supply voltage
at new home matches voltage specified on the model/serial
rating plate.
Shut off
electrical supply
to dryer.
Disconnect
power supply
cable from dryer.
Slide dryer onto cardboard or hardboard
before moving it across the floor to
prevent damaging floor covering.
Tape top
to cabinet.
Tape
door to
front
panel.
Turn
leveling
legs all the
way in.