Whirlpool 8533772 Kullanıcı Talimatları - Sayfa 5

Kurutucu Whirlpool 8533772 için çevrimiçi göz atın veya pdf Kullanıcı Talimatları indirin. Whirlpool 8533772 16 sayfaları. Whirlpool clothes dryer user manual

Sayfayı Yazdır

Starting Electronic Models

1. Load clothes loosely into the dryer and close the door. Do not

pack the dryer. Allow space for clothes to tumble freely.

2. Select one of the Automatic or Timed Cycles.

Use the Heavy Duty, Towels/Cotton or Normal cycles to

dry most heavyweight and medium weight fabrics.

If you select an Automatic Cycle, you may change the

dryness level. Press the plus (+) or minus (-) pads for

MORE DRY or LESS DRY.

If you select a Timed Cycle, you may change the time and

temperature settings. To change the time, press the plus

(+) or minus (-) pads to get MORE TIME or LESS TIME. To

change the temperature press the TIMED CYCLES TEMP

pad.

3. Select the WRINKLE SHIELD™ setting, if desired. When you

are unable to remove a load from the dryer as soon as it stops,

wrinkles can form. This feature periodically tumbles,

rearranges and fluffs the load without heat to help avoid

wrinkling.

4. Select the CYCLE SIGNAL, if desired. The signal is helpful

when drying items that should be removed from the dryer as

soon as it stops.

5. If desired, add fabric softener sheet. Follow package

instructions.

6. Push the START pad.

Stopping, Pausing and Restarting

You can stop your dryer anytime during a cycle.

To stop your dryer

Press PAUSE/CANCEL twice.

To restart your dryer

Close the door. Select a new cycle and temperature (if desired).

Push the START pad.

To pause your dryer

Open the door or press PAUSE/CANCEL once. Close the door

and press START to resume the cycle.

Cleaning the Dryer Location

Keep dryer area clear and free from items that would obstruct the

flow of combustion and ventilation air.

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as

gasoline, away from dryer.

Place dryer at least 18 inches (46 cm) above the floor

for a garage installation.

Failure to do so can result in death, explosion, or fire.

NOTE: Drying will continue from where the cycle was interrupted

if you close the door and press START within 5 minutes. If the

cycle is interrupted for more than 5 minutes, the dryer will shut off.

You will need to select new cycle settings before restarting the

dryer.

Use the Drying Rack to dry items such as sweaters and pillows

without tumbling. The drum turns, but the rack does not move.

NOTE: The rack must be removed for normal tumbling. Do not

use the automatic cycle with the drying rack.

To use the drying rack

1. Place drying rack in dryer.

Style 1: Your drying rack has front legs. Slide rear pegs into

the dimples on the back wall of the dryer. Lower the front legs

to rest on the dryer opening.

Style 2: Your drying rack does not have front legs. Do not

remove the lint screen. Slide drying rack over the bottom of

the dryer door opening. Push down to secure rack on frame.

2. Put wet items on top of rack, leaving space between items.

Do not allow items to hang over the edge of the rack. Close

the door.

3. Select a timed drying cycle and temperature, or an air cycle.

Items containing foam, rubber, or plastic must be dried on a

clothesline or by using an air cycle. Refer to the following

table.

4. Start the dryer. Reset cycle to complete drying, if needed.

Rack Dry

Washable wool items (block

to shape, lay flat on rack)

Stuffed toys/pillows (cotton

or polyester filled)

Stuffed toys/pillows

Foam rubber filled

DRYER CARE

Clean the lint screen before each load. A screen blocked by lint

can increase drying time.

IMPORTANT:

Do not run the dryer with the lint screen loose, damaged,

blocked, or missing. Doing so can cause overheating and

damage to both the dryer and fabrics.

If lint falls off the screen into the dryer during removal, check

the exhaust hood and remove the lint.

Every Load Cleaning

Style 1:

1. The lint screen is located on top of the dryer. Pull the lint

screen toward you. Roll lint off the screen with your fingers.

Do not rinse or wash screen to remove lint. Wet lint is hard to

remove.

2. Push the lint screen firmly back into place.

Drying Rack

Cycle

Timed

Drying

Timed

Drying

Air

(no heat)

Cleaning the Lint Screen

Temp

Time

Low

60 min.

Low

60 min.

N/A

90 min.