Whirlpool 8TCEM2760KQ0 Kurulum Talimatları Kılavuzu - Sayfa 13

Kurutucu Whirlpool 8TCEM2760KQ0 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Whirlpool 8TCEM2760KQ0 36 sayfaları. Commercial dryer – gas or electric

Sayfayı Yazdır

Power Supply Cord,

Three-wire electrical connection

This blade connected to

this conductor.

A. Spade terminals with upturned ends

B. Ring terminals

C. Neutral (white or center)

D. " UL-listed strain relief

E. Neutral

Three-wire power supply cord must

have three, No.-10 copper wires and

match a three-wire receptacle of NEMA

Type 10-30R.

Use this method where local codes permit connecting

neutral ground wire to neutral wire:

5. Loosen or remove the center terminal

block screw.

6. Connect the neutral wire (white or center)

of the power supply cord to the center,

silver-colored terminal screw of the

terminal block. Tighten screw.

7. Connect the other wires to outer terminal

block screws. Tighten screws.

8. Tighten strain relief screws.

9. Insert tab of the terminal block cover into

slot of the dryer rear panel. Secure cover

with hold-down screw.

Use this method where local codes do not permit

connecting neutral ground wire to neutral wire:

5. Remove the center terminal block screw.

6. Remove the appliance neutral ground wire

from the external ground conductor

screw. Connect the appliance neutral

ground wire and the neutral wire (white or

center) of the power supply cord under

the center, silver-colored terminal block

screw. Tighten screw.

7. Connect the other wires to outer terminal

block screws. Tighten screws.

8. Tighten strain relief screws.

9. Insert tab of the terminal block cover into

slot of the dryer rear panel. Secure cover

with hold-down screw.

10. After reattaching the terminal cover,

connect a separate copper ground wire

from the external ground conductor screw

to an adequate ground.

If codes permit and a separate ground wire is

used, it is recommended that a qualified

electrician determine that the ground path is

adequate.

A. External ground conductor screw

B. Center terminal block screw

C. Outer terminal block screws

D. Strain relief screw

E. Neutral (center wire)

F. Appliance neutral ground wire

A. Separate copper ground wire

B. External ground conductor screw

C. Appliance neutral ground wire

D. Center terminal block screw

E. Outer terminal block screws

F. Strain relief screw

G. Neutral (center wire)