Whirlpool AWZ 8000 Hızlı Referans Kılavuzu - Sayfa 3
Kurutucu Whirlpool AWZ 8000 için çevrimiçi göz atın veya pdf Hızlı Referans Kılavuzu indirin. Whirlpool AWZ 8000 5 sayfaları.
Sayfayı Yazdır
...you want to correctly
care for and clean your
dryer:
...you want to check the
dryer yourself first:
(If your machine is not
functioning correctly, please
check the following points
before phoning for the
customer service – also refer
to relevant chapter in the
instructions for use).
AFTER-SALES SERVICE
If the fault is still present once the above checks have been undertaken or should the fault occur for a second time, switch
the machine off. Please contact your after-sales service representative (for more information, refer to the warranty manual).
Please have the following details ready when calling your after-sales service representative:
• The nature of the fault.
• The dryer type and model.
• The service code (the number after the word Service on the
adhesive rating plate) on the right-hand side when the door is open.
How to proceed if ...
Clean the filter at the end
of every cycle.
Please de-install once a
year the air hose and
remove the lint inside.
Drying takes too long
laundry is not dry enough.
The dryer will not operate
(after a power failure,
always press the "Start
(Pause)" button).
Lint filter indicator lamp
on.
• Open the door.
• Pull the filter upwards.
• Brush lint using a soft brush or your
fingertips.
• Push the filter back into place.
• Has the correct drying programme
been selected?
• Was the inserted laundry too wet
(washing machine spin speed less than
1000 rpm?)
• Is the lint filter dirty (filter indicator
light on)?
• Is the room temperature too high?
• Are the "End" "
" and "Anticrease"
"
" indicator lamps lighting up? The
drying cycle is complete and the
laundry can be taken out.
• If the drying result does not meet your
expectation, select a more dry
programme.
• Is the plug properly inserted into the
mains electricity socket?
• Is there a power failure?
• Has the fuse blown?
• Is the door properly closed?
• Has a drying programme been
selected?
• Has the "Start (Pause)" button been
pressed?
• Has the start delay option been
selected ?
• Is the dryer overloaded? Please remove
a part of the load.
• Is the lint filter clean?
• Is the vent hose blocked?
• Is the outside vent hose adaptor blocked?
3