Whirlpool AWZ8CDS/PRO Sağlık & Güvenlik, Kullanım & Bakım ve Kurulum Kılavuzu - Sayfa 18
Kurutucu Whirlpool AWZ8CDS/PRO için çevrimiçi göz atın veya pdf Sağlık & Güvenlik, Kullanım & Bakım ve Kurulum Kılavuzu indirin. Whirlpool AWZ8CDS/PRO 32 sayfaları.
Sayfayı Yazdır
START DELAY
WATER
CONDUCTIVITY
SETTING
18
Enables to have the laundry ready at a
particular time by moving the start of
the programme to a later time .
Select programme and options .
Press the Start delay button – the
button lights up .
Turn the knob to select a delay up to
23 hours . and confirm by pressing the
knob .
Press Start / Pause - the display shows
the countdown of the delay until
start of the programme . The Start /
Pausebutton lights up . A sound by
activation of the pump may
occur .
The colon on the display between
hours and minutes blinks .
The drying results are affected by the
conductivity of the water used during
washing . If, by modifying the available
dryness levels (iron dry; cupboard dry;
extra dry), you are not satisfied with
the final drying results, you can adapt
the water conductivity level .
The dryer comes with preset level 2 .
Choose between
level 1
(most damp results)
and level 5
(most dry results) .
Press and hold the Programme
button until the Conductivity
Adjustment symbol on the
display blinks .
The programme starts automatically
at the end of the delay period . On
programme start, the delay on the
display is replaced by the remaining
programme duration .
When selecting a delay, the original
programme duration appears again
after the maximum possible delay of
23 hours . To exit the settings mode
again without setting a delay, select
the default programme duration .
To cancel a delay which has already
been started:
Either press Start/Pause to cancel
the delay . To start the selected
programme immediately, press Start/
Pause again .
Or press and hold On/Off to cancel the
complete programme setting .
Turn the knob to adjust the level (1 –2
– 3 – 4 - 5) . Press the knob to confirm
the selected level .
This operation is not needed for every
drying cycle . Once the most
satisfying water conductivity level has
been identified, you no longer need
to modify it .