Whirlpool CGW9100VQ0 Kurulum Kılavuzu - Sayfa 12

Kurutucu Whirlpool CGW9100VQ0 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Whirlpool CGW9100VQ0 40 sayfaları. Commercial dryer- gas or electric

Sayfayı Yazdır

INSTALLATION INSTRUCTIONS - GASDRYER

Excessive Weight Hazard

Use two or more people to move and install dryer.

Failure to do so can result in back or other injury.

1. Remove red cap from gas pipe on back of dryer.

2. Connect gas supply to dryer. Use a pipe thread compound

approved for the type of gas supplied. If flexible metal tubing

is used, be certain there are no kinks.

If necessary for service, open the front lower service panel by

using a V4" nutdriver to remove the 2 hex-head screws from

the bottom of the panel. Then lift up on the panel while pulling

the bottom of the panel away from the dryer.

3. Open the shutoff valve in the gas supply line and make sure

the unit has its own gas supply opened.

4. Test all connections by brushing on an approved noncorrosive

leak-detection solution. Bubbles will show a leak. Correct any

leak found.

1. Using a 4" (10.2 cm) clamp, connect vent to exhaust outlet

in dryer. If connecting to existing vent, make sure the vent is

clean. The dryer vent must fit over the dryer exhaust outlet

and inside the exhaust hood. Make sure the vent is secured

to exhaust hood with a 4" (10.2 cm) clamp.

2. Using two or more people, move dryer to desired installation

location. Do not crush or kink vent. Make sure dryer is level.

3. Check to be sure there are no kinks in the flexible gas line.

With dryer in final position, place level on top of the dryer, first

side to side; then front to back. }f the dryer is not level, adjust

the legs of the dryer up or down until the dryer is level.

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Fai{ure to follow these instructions can result in

death, fire, or electrical shock.

2. Plug into a grounded 3 prong outlet.

3. Check dryer operation (some accumulated

time may be on

the timer due to factory testing):

Close dryer door. Insert coins in slide and press slide in

slowly. (Operating time will accumulate per number of coins

and type of timing cam used.) Select the Whites

and Colors cycle and let the dryer run for at least five minutes.

NOTE:

Dryer door must be closed for dryer to operate.

4. Open the dryer door. Check that the inside of the dryer is

warm. If the burner does not ignite and you can feel no heat

inside the dryer, wait for five minutes. Check that all supply

valve controls are in "ON" position and that the electrical cord

is plugged in. Repeat five-minute test.

5. Check lint screen for debris and other obstructions.

6. Restart the dryer and allow it to complete the Whites and

Colors cycle to make sure it is working properly.