Whirlpool CSP2760TQ2 Kurulum Talimatları Kılavuzu - Sayfa 15

Kurutucu Whirlpool CSP2760TQ2 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Whirlpool CSP2760TQ2 36 sayfaları. Commercial stacked dryer gas (120-volt,60-hz)or electric (120/240-volt,60-hz)

Sayfayı Yazdır
Direct
Wire,
Three-wire electrical
connection:
Three wire with ground wire: green or bare
wire cut short. Wire is not used. Dryer is
grounded through neutral conductor.
A
to
disconnect
box
1" (25 mm)
of wires
stripped of
.... insulation
c
Shape ends
of wiresinto
a hook.
B
(89 mm)
Strip 31½'' (89 mm) of outer
covering from end of cable. Strip
insulation back 1" (25 mm). If using
3 wire cable with ground wire, cut
green or bare wire even with outer
covering.
A. 3/4"(19 ram) conduit connector
B. Neutral (white or center)
C. lO-gauge, 3 wire with ground wire
in flexible metallic conduit
Use this method where local codes permit
connecting neutral ground wire to
neutral wire:
5. Loosen or remove the center terminal
block screw.
6. Place the hooked end of the neutral wire
(white or center) of the direct wire cable
under the center screw of the terminal
block (hook facing right). Squeeze
hooked end together. Tighten screw.
7. Place the hooked ends of the other
direct wire cable wires under the outer
terminal block screws (hook facing right).
Squeeze hooked ends together. Tighten
screws.
8. Insert tab of the terminal block cover into
slot of the dryer rear panel. Secure cover
with hold-down screw.
A. External ground conductor screw
B. Center terminal block screw
C. Outer terminal block screws
D. Neutral (center wire)
E. Appliance neutral ground wire
Use this method where local codes do
not permit connecting neutral ground
wire to neutral wire:
5. Remove the center terminal block screw.
6. Remove the appliance neutral ground wire
from the external ground conductor screw.
Connect the appliance neutral ground wire
and the neutral wire (white or center) of the
direct wire cable under the center, silver-
colored terminal block screw. Tighten
screw.
7. Connect the other wires to outer terminal
block screws. Tighten screws.
8. Insert tab of the terminal block cover into
slot of the dryer rear panel. Secure cover
with hold-down screw.
9. After reattaching the terminal cover,
connect a separate copper ground wire
from the external ground connector screw
to an adequate ground.
If codes permit and a separate ground wire
is used, it is recommended
that a qualified
electrician determine that the ground path
is adequate.
E
A. Separate copper ground wire
B. External ground conductor screw
C. Appliance neutral ground wire
D. Center terminal block screw
E. Outer terminal block screws
F. Neutral (center wire)
15