Whirlpool Duet GEW9250PW Kullanım ve Bakım Kılavuzu - Sayfa 12

Kurutucu Whirlpool Duet GEW9250PW için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Whirlpool Duet GEW9250PW 24 sayfaları. Electronic electric dryer

Sayfayı Yazdır

Fire Hazard

Use a heavy metaB vent.

De net use a pmasticvent.

De net use a metam foil vent.

Failure to fellow

these instructions

can result in death

or fire.

WARNING;

To reduce the risk of fire, this dryer MUST BE

EXHAUSTED OUTDOORS.

4" (10.2 cm) heavy metal exhaust vent and clamps must be used.

DURASAFF Mvent products are recommended.

DURASAFF Mvent products can be purchased from your dealer

or by calling Whirlpool Parts and Accessories.

For more

information, see the "Assistance

or Service" section of this

manual.

•

The dryer exhaust must not be connected

into any gas vent,

chimney, wall, ceiling, or a concealed

space of a building.

•

Do not use an exhaust hood with a magnetic latch.

•

Do not install flexible metal vent in enclosed walls, ceilings or

floors.

Use clamps to seal all joints. Exhaust vent must not be

connected or secured with screws or other fastening devices

which extend into the interior of the duct. Do not use duct

tape.

IMPORTANT: Observe all governing codes and ordinances.

improper

venting

can cause moisture

and lint to collect

indoors, which

may resumt in:

[]

Moisture damage to woodwork,

furniture, paint,

wa!lpaper, carpets, etc.

[]

Housecleaning

probIems and health problems=

Use a heavy metal vent. Do not use plastic or metal foil vent.

Rigid metal vent is recommended

to prevent crushing and

kinking.

Flexible metal vent must be fully extended and supported when

the dryer is in its final position. Remove excess flexible metal vent

to avoid sagging and kinking that can result in reduced airflow

and poor performance.

An exhaust hood should cap the vent to prevent rodents and

insects from entering the home.

Exhaust hood must be at least 12" (30.5 cm) from the ground or

any object that is in the path of the exhaust (such as flowers,

rocks or bushes, etc.).

If using an existing vent system, clean lint from the entire length

of the system and make sure exhaust hood is not plugged with

lint. Replace any plastic or metal foil vent with rigid metal or

flexible metal vent.

Typical exhaust

installations

Typical installations vent the dryer from the rear of the dryer.

Other installations are possible.

A. Dryer

B. Elbow

C. Wall

D. Exhaust hood

E. Clamps

E Rigid metal or flexible metal vent

G. Vent length necessary to connect elbows

H. Exhaust outlet

Optional

exhaust installations

This dryer can be converted to exhaust out the right side, left

side, or through the bottom. Contact your local dealer to have the

dryer converted.

Fire Hazard

Cover unused exhaust

ho_es with one of the

following

kits:

279818 (white)

279925 (biscuit)

279969 (pewter)

Contact your mocat dealer.

FaiJure to follow

these instructions can resumt in death,

fire, electrical

shock, or serious

injury.