ABB ControlNet FCNA-01 Hızlı Kurulum ve Başlatma Kılavuzu - Sayfa 2
Kontrol Ünitesi ABB ControlNet FCNA-01 için çevrimiçi göz atın veya pdf Hızlı Kurulum ve Başlatma Kılavuzu indirin. ABB ControlNet FCNA-01 2 sayfaları. Adapter module
Connection procedure
Connect the bus cable to the BNC connectors [A] and/or [B] on the module. Use both connectors
in redundant operation, otherwise use either connector [A] or [B].
Start-up
To control the drive with the adapter module, set at least the basic parameters listed in the table
below. For full parameter descriptions, refer to the adapter module's user manual or to the drive's
firmware manual.
Basic parameter settings
Index
Name
20.01
Ext1 commands
22.11
Speed ref1 source
28.11
Frequency ref1 source FBA A ref 1
50.01
FBA A enable
50.02
FBA A comm loss func Fault
51.02
Profile
To take the settings into use, validate and refresh the parameters with parameter 51.27 FBA par
refresh. Set the node address of the device with the rotary switches on the module.
Further information
See the latest version of FCNA-01 ControlNet adapter module
user's manual (3AUA0000141650 [English]) in ABB library
(www.abb.com/drives/documents).
FCNA-01 manual
abb.com/drives
© Copyright 2023 ABB. All rights reserved.
Specifications subject to change without notice.
Value
Fieldbus A
FBA A ref 1
Enable (or select the option slot in which the module is installed)
The ODVA AC/DC drive profile is the default value.
For more information on ABB fieldbus options and protocols,
see the fieldbus communications web page
(new.abb.com/drives/connectivity/fieldbus-connectivity).
Fieldbus communications web page