Whirlpool WGD7990XG0 Kurulum Talimatları Kılavuzu - Sayfa 13
Kurutucu Whirlpool WGD7990XG0 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Whirlpool WGD7990XG0 32 sayfaları. Gas dryer
Ayrıca Whirlpool WGD7990XG0 için: Kurulum Talimatları Kılavuzu (32 sayfalar)
Sayfayı Yazdır
Attach long hose to "Y"
connector
and tighten couplings
Turn on cold water faucet
Check that the water faucets are turned on.
One end of the long hose has a wire mesh strainer inside the
coupling. Attach this end to the "Y" connector. Attach washer
cold inlet hose to other side of "Y" connector. Screw on
coupling by hand until it is seated on connector.
Using pliers,
tighten the couplings an additional two-thirds turn.
NOTE: Do not overtighten. Damage to the coupling can result.
5,
Attach
long hose to dryer fill
valve and tighten
coupling
Attach other end of long hose to fill
valve at bottom of dryer back panel.
Screw on coupling by hand until it
is seated on fill valve connector.
Using pliers, tighten the couplings an additional two-thirds
turn.
NOTE: Do not overtighten. Damage to the coupling can result.
Check for leaks
Check for leaks around "Y" connector, faucet, and hoses.
NOTE: Replace intlet hoses after 5 years of use to reduce the
risk of hose failure. Record hose installation or replacement
dates on the hoses for future reference.
Periodically inspect and replace hoses if bulges, kinks, cuts,
wear, or leaks are found.
CON_CT
¥%NW
, Connect
vent to exhaust
outlet
Using a 4" (102 mm) clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sure vent is
clean. Dryer vent must fit over dryer exhaust outlet and inside
exhaust hood. Check that vent is secured to exhaust hood
with a 4" (102 mm) clamp.
13