Whirlpool WGD85HEFC Kurulum Talimatları Kılavuzu - Sayfa 16

Kurutucu Whirlpool WGD85HEFC için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Whirlpool WGD85HEFC 16 sayfaları.

Sayfayı Yazdır

DOOR REVERSAL (OPTIONAL)

The following instructions are for models with a round and
square-shaped doors.
Tools needed:
Min. 8" long TORX T25
®
††
screwdriver
Reverse door swing round-shaped door flat glass –
single handle
1.
Remove door from dryer
IMPORTANT: If the protective film has not yet been
removed from the dryer, peel the film from the dryer
door before proceeding.
®
Using a T25
screwdriver, remove the 4 screws securing the
door hinge to the dryer and lift up and out to remove the door.
Place the door on a soft towel or other non-scratch surface.
Reinstall the 4 screws in the holes.
16
#2 Phillips screwdriver
2.
Move the door strike
Using a T25
®
screwdriver, remove the 2 screws securing the
door strike to the door frame of the dryer. Rotate the strike
180° and attach to the opposite side of dryer door frame
as shown.
3.
Remove inner door from outer door
Position the door with the inside of the door facing up.
Using a Phillips screwdriver, remove the 10 screws securing
the inner door to the outer door. Lift off the inner door and
set aside.
††
® TORX and T25 are registered trademarks of Acument Intellectual Properties, LLC.