Whirlpool WGD9250WR - Duet Cranberry - Gas Dryer Kurulum Talimatları Kılavuzu - Sayfa 9

Kurutucu Whirlpool WGD9250WR - Duet Cranberry - Gas Dryer için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Whirlpool WGD9250WR - Duet Cranberry - Gas Dryer 28 sayfaları. Installation instructions
Ayrıca Whirlpool WGD9250WR - Duet Cranberry - Gas Dryer için: Kullanım ve Bakım Kılavuzu (24 sayfalar)

Whirlpool WGD9250WR - Duet Cranberry - Gas Dryer Kurulum Talimatları Kılavuzu

VeNTING reQUIreMeNTS

WARNING:
To reduce the risk of fire, this dryer MUST BE
EXHAUSTED OUTDOORS.
IMPORTANT:
Observe all governing codes and ordinances.
Dryer exhaust must not be connected into any gas vent,
chimney, wall, ceiling, attic, crawlspace, or a concealed space
of a building. Only rigid or flexible metal vent shall be used for
exhausting.
Only a 4" (102 mm) heavy metal exhaust
n
vent and clamps may be used.
Do not use plastic or metal foil vent.
n
Rigid metal vent:
Recommended for best drying performance and to prevent
n
crushing and kinking.
Flexible metal vent:
(Acceptable only if accessible to clean)
Must be fully extended and supported in final dryer location.
n
Remove excess to avoid sagging and kinking that may result
n
in reduced airflow and poor performance.
Do not install in enclosed walls, ceilings, or floors.
n
The total length should not exceed 7
n
NOTE:
If using an existing vent system, clean lint from entire
length of the system and make sure exhaust hood is not plugged
with lint. Replace plastic or metal foil vents with rigid metal or
flexible metal vents. Review Vent system chart and if necessary,
modify existing vent system to achieve best drying performance.
Exhaust hoods:
Must be at least 12" (305 mm) from ground or any object that
n
may obstruct exhaust (such as flowers, rocks, bushes, or
snow).
B
A
4"
(102 mm)
4"
(102 mm)
Recommended styles:
A. Louvered hood
B. Box hood
An exhaust hood should cap vent to keep rodents and insects
n
from entering home.
Do not use exhaust hood with a magnetic latch.
n
/
ft. (2.4 m).
3
4
C
4"
(102 mm)
2½"
(64 mm)
Acceptable styles:
C. Angled hood
Elbows:
45° elbows provide better airflow than 90° elbows.
n
Good
Clamps:
Use clamps to seal all joints.
n
Exhaust vent must not be connected or secured with screws
n
or other fastening devices that extend into interior of duct
and catch lint. Do not use duct tape.
Improper venting can cause moisture and lint
to collect indoors, which may result in:
Moisture damage to woodwork, furniture, paint, wallpaper,
n
carpets, etc.
Housecleaning problems and health problems.
n
Vent products can be purchased from your dealer or by calling
Whirlpool Service. For more information, see "Assistance
or Service" section in your Use and Care Guide.
Better
9