Whirlpool WGD9371YW Kurulum Kılavuzu - Sayfa 14

Kurutucu Whirlpool WGD9371YW için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Whirlpool WGD9371YW 36 sayfaları. Installation guide
Ayrıca Whirlpool WGD9371YW için: Kullanıcı Kılavuzu (32 sayfalar), Kullanım Kılavuzu (8 sayfalar), Kullanım ve Bakım Kılavuzu (40 sayfalar)

Sayfayı Yazdır
Whirlpool WGD9371YW Kurulum Kılavuzu

CONNECT INLET HOSE

(Steam models only)
For non-steam models, proceed to "Connect Vent".
The dryer must be connected to the cold water faucet using the
new inlet hoses. Do not use old hoses.
NOTE: Replace inlet hoses after 5 years of use to reduce the risk
of hose failure. Record hose installation or replacement dates on
the hoses for future reference.
Periodically inspect and replace hoses if bulges, kinks, cuts,
wear, or leaks are found.
1.
Turn cold water off, remove hose,
and replace rubber washer
Turn cold water faucet off and remove washer inlet hose.
Check and see if rubber washer is in the "Y" connector.
Remove old rubber washer from inlet hose and replace with
new rubber washer provided.
2.
Attach short hose and
"Y" connector
A
If space permits, attach the female end of the "Y" connector
to the cold water faucet. See figure A.
If "Y" connector cannot be attached directly to the cold water
faucet, the short hose must be used. See figure B. Attach
short hose to cold water faucet. Screw on coupling by hand
until it is seated on faucet. Then attach "Y" connector to male
end of the short hose. Screw on coupling by hand until it is
seated on connector.
14
3.
Tighten couplings
Using pliers, tighten the couplings with additional
two-thirds turn.
NOTE: Do not overtighten. Damage to the coupling
can result.
4.
Attach long hose to "Y"
connector and tighten couplings
One end of the long hose has a
wire mesh strainer inside the coupling. Attach this end to the
"Y" connector. Attach washer cold inlet hose to other side of
"Y" connector. Screw on coupling by hand until it is seated
on connector. Using pliers, tighten the couplings an additional
B
two-thirds turn.
NOTE: Do not overtighten. Damage to the coupling can result.