Whirlpool YGEW9250PL0 Kullanım ve Bakım Kılavuzu - Sayfa 10

Kurutucu Whirlpool YGEW9250PL0 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Whirlpool YGEW9250PL0 40 sayfaları. Electronic electric dryer

Sayfayı Yazdır

Check t helevelness ofthedryer. Check l evelness first

side toside, t hen front t oback.

Ifthedryer i snotlevel, propupthedryer u sing awood block.

Use awrench t oadjust thelegs upordown andcheck again f or

levelness.

NOTE: It might b enecessary tolevel thedryer a gain after i thas

been moved i ntoitsfinal p osition.

1. Using a 4"(10.2 cm) c lamp, connect vent t oexhaust outlet i n

dryer. Ifconnecting toexisting v ent, m ake sure thevent i s

clean. The dryer v ent m ust f itover t hedryer e xhaust outlet

andinside theexhaust hood. M ake sure thevent i ssecured

toexhaust hood witha4"(10.2 cm) c lamp.

2. Move dryer i ntofinal p osition. Donotcrush orkinkvent.

Make sure dryer i s level.

3. (On gasmodels) Check t obesure there arenokinks inthe

flexible g asline.

1. Check t obesure allparts arenowinstalled. Ifthere isan

extra part, g oback through t hesteps toseewhich step was

skipped.

2. Check t obesure youhave allofyour t ools.

3. Dispose ofallpackaging materials.

4. Check t hedryer's f inal l ocation. Besure thevent i snot

crushed o rkinked.

5. Check t obesure thedryer i slevel. S ee "Level Dryer."

6. Plug intoagrounded outlet. Turn power o n.

7. Remove theblue protective filmontheconsole a ndany tape

remaining onthedryer.

8. Read "Dryer Use."

9. Wipe thedryer d rum interior thoroughly witha damp cloth to

remove anydust.

10.Setthedryer o nafullheat c ycle (not a naircycle) for

20minutes a nd start t hedryer.

If the dryer will not start, check the following:

•

Controls are set in a running or "On" position.

•

Start button has been pushed firmly.

•

Dryer is plugged into a grounded outlet.

•

Electrical supply is connected.

•

House fuse is intact and tight, or circuit breaker has not

tripped.

•

Dryer door is closed.

11. When the dryer has been running for 5 minutes, open the

dryer door and feel for heat.

If you do not feel heat, turn the dryer off and check the

following:

•

There may be 2 fuses or circuit breakers for the dryer. Check

to make sure both fuses are intact and tight, or that both

circuit breakers have not tripped. If there is still no heat,

contact a qualified technician.

NOTE: You may notice a burning odor when the dryer is first

heated. This odor is common when the heating element is first

used. The odor will go away.