Whirlpool YWED94HEAC Kurulum Talimatları Kılavuzu - Sayfa 15
Kurutucu Whirlpool YWED94HEAC için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Whirlpool YWED94HEAC 22 sayfaları. Gas dryer
Sayfayı Yazdır
COMPLETE INSTALLATION
CHECKLIST
q
Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
q
Check that you have all of your tools.
q
Dispose of/recycle all packaging materials.
q
Be sure the water faucets are on.
q
Check for leaks around "Y" connector, faucet, and hoses.
q
Check dryer's final location. Be sure vent is not crushed
or kinked.
q
Check that dryer is level. See "Level Dryer."
q
Remove film on console and any tape remaining on dryer.
q
Wipe dryer drum interior thoroughly with a damp cloth to
remove any dust.
q
Read "Dryer Use" in your Use and Care Guide.
q
If you live in a hard water area, use of a water softener is
recommended to control the buildup of scale through the
water system in the dryer. Over time, the buildup of lime
scale may clog different parts of the water system, which will
reduce product performance. Excessive scale buildup may
lead to the need for certain part replacement or repair.
Electric Models
q
Plug into a grounded outlet.
Gas Models
q
Plug into a grounded outlet.
q
Check that gas supply is on.
q
Check for leaks.
q
Check to be sure that the flexible gas line is not crushed
or kinked.
All Models:
q
Select a Timed Dry heated cycle, and start dryer. Do not
select Air Only Temperature setting.
If dryer will not start, check the following:
• Start button has been pressed firmly.
• Dryer is plugged into an outlet and/or electrical supply is
connected.
• Household fuse is intact and tight, or circuit breaker has
not tripped.
• Dryer door is closed.
This dryer automatically runs an installation diagnostic routine
at the start of its first cycle.
NOTE:
You may notice an odor when dryer is first heated. This
odor is common when heating element is first used. The odor will
go away.
DOOR REVERSAL (OPTIONAL)
The following instructions are for models with a round and
square-shaped doors.
Tools needed:
Min. 8" long TORX
®
††
T25
screwdriver
®
††
Reverse door swing round-shaped door – single handle
1.
Remove door from dryer
IMPORTANT: If the protective film has not yet been
removed from the dryer, peel the film from the dryer
door before proceeding.
Using a TORX
T25
screwdriver, remove the 4 screws
®
®
securing the door hinge to the dryer and lift up and out to
remove the door. Place the door on a soft towel or other
non-scratch surface. Reinstall the 4 screws in the holes.
® TORX and T25 are registered trademarks of Acument Intellectual Properties, LLC.
††
#2 Phillips screwdriver
15