Acom International ACOM Exhibit 8 1000 Kullanıcı Kılavuzu - Sayfa 4
Amplifikatör Acom International ACOM Exhibit 8 1000 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Acom International ACOM Exhibit 8 1000 17 sayfaları. External radio frequency power amplifier
Sayfayı YazdırC A U T I O N notes call attention to a procedure which, if not correctly performed, could result in equipment damage,
not only in the amplifier.
N O T E notes call attention to a procedure which, if not correctly performed, could result in inconvenience.
W A R N I N G HIGH VOLTAGE!
The amplifier works with high voltages up to 3000V, which are LETHAL! Also, for your safety, pull the amplifier power
plug out of the mains wall outlet and WAIT AT LEAST 30 minutes EACH TIME BEFORE you remove the cover of the
amplifier. Do not touch any part inside while the amplifier is open because some residual voltages may still be present.
W A R N I N G HIGH VOLTAGE!
NEVER ALLOW ANYONE, ESPECIALLY CHILDREN,
to push anything into holes in the case - this will cause electric shock. NEVER TOUCH AN ANTENNA during
transmission - this may result in an electric shock or burn. NEVER EXPOSE the amplifier to rain, snow or any liquids.
AVOID placing the amplifier in excessively dusty environments or in direct sunlight. DO NOT OBSTRUCT AIR INTAKE
(rear panel) and EXHAUST (top cover) areas of the amplifier. Keep a minimum distance of 10cm (4 inches) to the intake
and 50cm (20 inches) to the exhaust.
W A R N I N G
Do not undertake on your own repairs or changes in hardware or software of the amplifier. Otherwise you may endanger
your or other's health and life or damage the amplifier and the equipment connected with it, not covered by warranty.
The manufacturer is not liable for another's actions and responsibility shall be assumed by the doer.
C A U T I O N
To avoid damage (not covered under warranty) read the Installation - Section 2 of this operating manual carefully. If you
have any doubts about the installation, operation or safeties of the amplifier please consult your dealer.
N O T E
Before you start to install the amplifier, thoroughly read this manual. First, carefully inspect the cardboard carton and its
contents for physical damage. If damage is noticed, notify your dealer immediately. Delay may infringe carrier's warranty
conditions. Keep all packing for possible future transportation!
C A U T I O N
To avoid damage (not covered under warranty), check carefully if the voltage for which the amplifier is set corresponds
to your mains nominal voltage.
Normally the amplifier is supplied set for a nominal line voltage of 240V. There might be exceptions in cases of special
delivery and then the voltage set is noted in the Table of Individual Data (Table 2-1). If your power line has a different
nominal voltage, it will be necessary for you to contact your dealer.
AMP s/n
Tube s/n
Voltage Selector
Exhibit 8
2. INSTALLATION
2-1. Unpacking and Initial Inspection
2-2. Line Voltage Selection
TABLE 2-1. ACOM 1000 INDIVIDUAL DATA
2-3. Amplifier Location Selection
VAC
4 -17
4