Clank Chaos Manuel - Sayfa 3

Kayıt Ekipmanları Clank Chaos için çevrimiçi göz atın veya pdf Manuel indirin. Clank Chaos 12 sayfaları.
Ayrıca Clank Chaos için: Manuel (10 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar)

Sayfayı Yazdır

Getting Started

Make sure your system is turned off, then connect

the module to the power bus using the ten to

sixteen IDC cable provided. The red line on the

cable corresponds to the -12V power rail. On the

back of the module a thick white line indicates

where the -12V rail is located on the IDC connector.

Before powering up make sure to have completely

installed the module by using the four panel screws

provided. Devices must stay firm inside their case.

Make sure the back is not touching other objects

inside the case. The exposed electronics may

cause shortcuts when coming into contact with

other electronic surfaces or objects.

Dimensions

12Hp

Power Consumption

+12V: 115mA

-12V: 0mA

+5V: 0mA

Warranty Policy

Clank offers a two-year period of warranty on

each product purchased from our site. During this

period all defective or malfunctioning devices will

be repaired or even substituted with a new unit.

Shipping costs will be refunded by Clank. This

service will be applied unless an external damage

is proven to have happened. Only Clank is allowed

to repair its own products. Any external attempts

of repair/modding will void the warranty. In case

of out of warranty damages, devices can also be

sent for servicing. In this case shipping costs must

be covered by the owner. Requests must be sent

by email to the following address: [email protected]

DO NOT FORGET:

•

The purchase invoice number always has to

be communicated by email when requesting

servicing and must subsequently be included

inside the shipped box containing the module

•

Only units shipped with their own packaging

will be serviced/repaired

•

The packaging provided is not meant to be a

shipping box itself. When shipping back, put

everything inside a larger shipping enclosure

•

Remember to fill the gaps between the

module and its packaging and also between

the packaging and the shipping box with

some shock absorbing foam/paper

•

We are not responsible for improper boxing

and shipping damages

Safety Instructions

•

Do not power up your system before the

module is completely installed

•

Never use or power up the module with the

back panel exposed

•

If you ever see sparks coming from the

module or its circuit or see or smell fumes

while the module is turned on, please turn

off the power supply immediately. Exposure

to erroneous voltages, currents, or shortcuts

can damage the device in a few seconds

•

Never turn the module on if there is water

inside or on the case

•

Never turn the module on if any external tools

or objects have fallen inside the case

•

Never use the module in environments

with temperatures below 0°C or over

50°C degrees. In case of long exposure to

unwanted temperatures let the device rest

at an acceptable temperature for at least 30

minutes or until cooled down before powering

•

The front panel may warm up because of

continued usage. A temperature of up to 30°C

is acceptable for use and functioning.