AER amp one Kullanıcı Kılavuzu - Sayfa 6

Amplifikatör AER amp one için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AER amp one 12 sayfaları. Aer bottom-line series amp one user manual

Sayfayı Yazdır

4. Starting up

4.1 Cabling and Switching on

Before connecting to the mains, please ensure that

your local mains voltage is suitable for the voltage of

red and switch the amplifier on. The green power

control LED indicates operational readiness.

4.2 Level Adjustment

Note: Level adjustment

By setting the level correctly we mean the signal level

in one or several devices in a signal chain is neither

too high nor too low. This applies equally to all com-

ponents of a unit (e.g. equalizer, tone balance, com-

pressor).

Consequently, care must be taken that no part of the

circuit is overloaded or that distortion is unintentio-

nally added to the signal. We have carefully designed

the circuit to achieve this objective whilst also provi-

ding controls (gain, master, level) for manual interven-

tion.

but does not reach the loudspeaker, while you are ad-

justing the level.

Turn the gain control clockwise until the red clip indi-

cator flashes momentarily when playing with a strong

attack. Thus you make sure that your signal source

(e.g. instrument) provides the input-stage of the amp-

lifier with the necessary input level.

An illuminated clip-LED indicates an overload. A short

flicker is no danger to AER devices. During operation

a short flicker can be accepted, to be on the safe side

you should reduce the gain slightly to achieve an opti-

mal and distortion-free performance.

the device (e.g. 120V in

the USA, 230V in Europe).

The relevant specs and sa-

fety symbols are printed

on the rear side of the

unit.

Connect all cables as desi-

First ensure, that the mute

switch is deactivated and

the master level control is

zeroed (over to far left),

so that the signal passes

through

the

electronics

Just like the gain control, the high/low switch (attenua-

tor de-/activation) also serves to adjust the signal. Start

at high with the switch not pressed down. If the in-

put signal is too strong and you cannot avoid clipping

even when you adjust with the gain control, then se-

lect the low setting.

When you have adjusted the sound level, then you

can set the desired final volume with the master con-

trol.