Whirlpool 30" WALL-MOUNT CANOPY RANGEHOOD Kurulum Talimatları ve Kullanım & Bakım Kılavuzu - Sayfa 6

Havalandırma Davlumbazı Whirlpool 30" WALL-MOUNT CANOPY RANGEHOOD için çevrimiçi göz atın veya pdf Kurulum Talimatları ve Kullanım & Bakım Kılavuzu indirin. Whirlpool 30" WALL-MOUNT CANOPY RANGEHOOD 28 sayfaları. 30" (76.2 cm) wall-mount canopy range hood

Sayfayı Yazdır

For Non-Vented (recirculating) Installations

If it is not possible to vent cooking fumes and vapors to the

outside, the hood can be used in the non-vented (recirculating)

version, by fitting a charcoal filter and the deflector. Fumes and

vapors are recycled through the top grille. See the "Assistance

or Service" section for information on ordering.

Roof Venting

Wall Venting

A. Roof cap

A. Wall cap

B. 6" (15.2 cm)

round vent

Calculating Vent System Length

To calculate the length of the system you need, add the

equivalent feet (meters) for each vent piece used in the system.

Vent Piece

45° elbow

90° elbow

Maximum equivalent vent length is 35 ft (10.7 m).

Example vent system

90 elbow

6 ft (1.8 m)

2 ft

(0.6 m)

The following example falls within the maximum recommended

vent length of 35 ft (10.7 m).

1 - 90° elbow

= 5.0 ft (1.5 m)

1 - wall cap

= 0.0 ft (0.0 m)

8 ft (2.4 m) straight

= 8.0 ft (2.4 m)

Length of system

= 13.0 ft (3.9 m)

Non-vented

(recirculating)

A. Deflector

B. 6" (15.2 cm)

round vent

6" (15.2 cm) Round

2.5 ft

(0.8 m)

5.0 ft

(1.5 m)

Wall cap

Electrical Requirements

Observe all governing codes and ordinances.

Ensure that the electrical installation is adequate and in

conformance with National Electrical Code, ANSI/NFPA 70 (latest

edition), or CSA Standards C22.1-94, Canadian Electrical Code,

Part 1 and C22.2 No. 0-M91 (latest edition) and all local codes

and ordinances.

If codes permit and a separate ground wire is used, it is

recommended that a qualified electrician determine that

the ground path is adequate.

A copy of the above code standards can be obtained from:

National Fire Protection Association

1 Batterymarch Park

Quincy, MA 02169-7471

CSA International

8501 East Pleasant Valley Road

Cleveland, OH 44131-5575

■

A 120 volt, 60 Hz., AC only, 15-amp, fused electrical circuit

is required.

■

If the house has aluminum wiring, follow the procedure

below:

1. Connect a section of solid copper wire to the pigtail

leads.

2. Connect the aluminum wiring to the added section of

copper wire using special connectors and/or tools

designed and UL listed for joining copper to aluminum.

Follow the electrical connector manufacturer's recommended

procedure. Aluminum/copper connection must conform with

local codes and industry accepted wiring practices.

■

Wire sizes and connections must conform with the rating

of the appliance as specified on the model/serial/rating plate.

The model/serial/rating plate is located behind the left filter

on the rear wall of the range hood.

■

Wire sizes must conform to the requirements of the National

Electrical Code, ANSI/NFPA 70 (latest edition), or CSA

Standards C22. 1-94, Canadian Electrical Code, Part 1

and C22.2 No. 0-M91 (latest edition) and all local codes

and ordinances.