FirePro FPC-1 Teknik Kılavuz - Sayfa 3

Kontrolör FirePro FPC-1 için çevrimiçi göz atın veya pdf Teknik Kılavuz indirin. FirePro FPC-1 7 sayfaları. Fire detection and extinguishant controller, self-contained aerosol activation module

Sayfayı Yazdır
FirePro
Technical Manual
4.
Connect the optional remote activation switch to the "Remote Activation" terminal,
if required. Connect the 5.1K End of Line resistor to the switch as indicated by Figure 2.
If the system is supervised by a Building Management System (BMS), connect the Alarm
(AL), Trouble (TR), and Watchdog, (WD) open-collector outputs to the appropriate BMS
inputs. Secure the cable mechanically with a tie wrap. Insert four alkaline AA batteries in
the battery pack and connect it to connector JP3 (see Figure 2).
5.
Ensure proper operation – the green LED flashes every 10 seconds to indicate a
normal status.
6.
Close the module's cover – take care of the location of the sensor and LEDs.
Warning
The FPC-1 is a self-contained activation module for extinguishing devices that
operate by activation of an electric igniter supplied with aerosol extinguishers
manufactured by FirePro. The FPC-1 is not intended to replace fire alarm systems
that include a control panel, remote annunciators, smoke detectors, heat
detectors, call points, sounders, strobes, and extinguishing devices as required
by standards and regulations applicable to the installed location.
Conform to the country's relevant standards and regulations applicable to the system's
location when installing automatic extinguishing systems. Some applications are not
compatible with the FPC-1 due to regulations, local laws, or applicable standards. Ensure
that the requirements and regulations relevant to the installed location do not prohibit
such a system. The FPC-1 is intended for applications where relevant regulations do not
specify a fire alarm and extinguishing system.
products are manufactured by FirePro Systems Ltd
FirePro
®
®
Keep this Technical Manual for future use. This
manual lapses when revised. The latest version
is obtainable from FirePro Systems Ltd.
Version 1, 01-07-2010
Figure 2
FPC-1 Connection
Page 2 of 6