Whirlpool 883147 Kurulum Talimatları Kılavuzu - Sayfa 5

Havalandırma Davlumbazı Whirlpool 883147 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Whirlpool 883147 7 sayfaları.

Sayfayı Yazdır

_ .

!&wlA II

If\1

green grounding

screw

Remove terminal box cover.

Connect the white and black wires of the

power supply cable to the white and black

leads in the hood with twist-on connectors,

Connect the power supply grounding wire

to the green, grounding wire inside the

range terminal box with a twist-on wire

connector.

Use caulking to seal wire opening.

Replace terminal box cover.

Pull firmly on tab to remove filter/light lens

from range hood. Turn filter/light lens so that

charcoal

filter pad is facing up. Lift tabs and

remove charcoal

filter pad. Discard

charcoal

filter pad. Place edge of filter/light

lens in opening so that right side is above

flange and tab faces downward.

Press

filter/light lens into position.

Non-vented

installation

Check vent baffle on top of range hood.

"Non-vented"

should be facing up.

Remove knockout from the wiring opening

(rear or top) to be used.

Do Not remove venting knockouts.

terminal

box

cover

Remove terminal box cover on range

hood.

Personal Injury Hazard

More than one person is required to

help with appliance

installation

because of its weight and size.

Failure to follow these instructions may

result in personal injury.

keyhole

slot

4 6

L----i-

Lift range hood into final position and

center. Mark on underside of cabinet the

location for the four keyhole mounting slots.

Set range hood uside on a protected

surface.

6.-

centerline

To wire through top, mark a line 7-l /2" from

the right of the centerline on the underside

of the cabinet. Mark the point on this line

that is l-3/8" from the back wall. Drill a

l-l /4" diameter hole through cabinet at this

point.

centerline

To wire through rear, mark a line 7-l /2" from

the right of the centerline on the wall. Mark

the point on this line that is 64-5/8" from the

floor (or l-3/8" from underside of cabinet).

Drill a l-l /4" diameter hole through wall at

this point.

Replace terminal box cover. Continue

installation with Step 13, Panel C.

/$jiiJi~~~~ij

Keep Installation Instructions

[ Congratulations!

)

reference. The instructions will

make reinstalling your Whirlpool

cent&line

IL!

Determine and clearly mark a vertical

centerline in the area the vent opening will

be made.

Panel D