Whirlpool AKR290/WH Kullanım Kılavuzu - Sayfa 8

Havalandırma Davlumbazı Whirlpool AKR290/WH için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Whirlpool AKR290/WH 13 sayfaları.

Electrical Connection

1. Make sure the power voltage specified on the appliance rating plate is the same as the mains voltage.

This information can be found inside the hood,

2. Before reconnecting the hood circuit to the power supply and checking correct operation, always

make sure the power cable is correctly fitted and that it was NOT crushed in its housing during

installation. Make sure to have this operation carried out by a qualified technician in accordance with

all local codes and standards.

3. Turn off electrical power before installation

4. If supply cord is damaged, please call manufacturer for replacement to avoid any electrical hazards

5. Do not use plug and extension cord other than the one provided

6. Earthing of the hood is compulsory. Do not remove ground prong of the plug.

General Recommendations

Before use

Remove cardboard protection pieces, protective film and adhesive labels from accessories.

Check the appliance for any damage caused by transport.

During use

To avoid any damage do not place any weights on the appliance.

Do not expose the appliance to atmospheric agents.

This is a heavy product; the hood should only be lifted and installed by two or more people.

Installation

Position

1. The minimum installation height should not be less than 650mm and the recommended height is

700±50 mm. (Fig. 5.)

2. Avoid left-right or front-dropped inclination. Make sure hood is installed correctly with correct

alignment.

Mount the hood body

1. Drill the holes according to the distances indicated in Fig5,Fig.6 and Fig7.

2. Fix the support bracket to the wall and hook the hood on the support bracket for hooking it to the

wall. Adjust the distance between the hood and wall and align it in horizontal position to the wall

units. Adjust the hood horizontally using a level.

3. When the appliance has been adjusted, fully tighten the support using the screws. The hood comes

with all the materials required for installation on the majority of walls. All installations must be done