Whirlpool GZ5736 Series Kurulum Talimatları ve Kullanım ve Bakım Kılavuzu - Sayfa 4

Havalandırma Davlumbazı Whirlpool GZ5736 Series için çevrimiçi göz atın veya pdf Kurulum Talimatları ve Kullanım ve Bakım Kılavuzu indirin. Whirlpool GZ5736 Series 21 sayfaları. 30" (76.2 cm) and 36" (91.4 cm) convertible range hood

Sayfayı Yazdır
3-1/4" x 10" (8.3 x 25.4 cm) vent system
3-1/4" x 10"
(8.3 x 25.4 cm)
elbow
6 ft. ( 1.8 m)
2 ft.
(0.6 m)
Recommended standard fittings
3-1/4" x 10"
(8.3 x 25.4 cm)
90° elbow =
5 ft. (1.5 m)
90° elbow
2 ft. (0.6 m)
Recommended standard fittings
90° elbow =
45° elbow =
5 ft. (1.5 m)
2.5 ft. (0.8 m)
4
wall cap
Maximum length
1 - 90° elbow
8 ft. (2.4 m) straight
1 - wall cap
Length of 3-1/4" x
10" (8.3 x 25.4 cm)
system
3-1/4" x 10"
3-1/4" x 10"
(8.3 x 25.4 cm)
(8.3 x 25.4 cm)
flat elbow =
wall cap =
12 ft. (3.7 m)
0 ft. (0 m)
7" (17.8 cm) vent system
wall cap
6 ft. (1.8 m)
Maximum length
1 - 90° elbows
1 - wall cap
8 ft. (2.4 m) straight =
Length of 7"
(17.8 cm) system
3-1/4" x 10"
7" (17.8 cm)
(8.3 x 25.4 cm) to
wall cap =
7" (17.8 cm) =
0 ft. (0 m)
4.5 ft. (1.4 m)
= 65 ft. (19.8 m)
= 5 ft. (1.5 m)
= 8 ft. (2.4 m)
= 0 ft.
(0 m)
= 13 ft.
(4 m)
=
65 ft. (19.8 m)
=
5 ft. (1.5 m)
=
0 ft.
(0 m)
8 ft. (2.4 m)
=
13 ft.
(4 m)
3-1/4" x 10"
(8.3 x 25.4 cm)
to 7" (17.8 cm)
90° elbow =
5 ft. (1.5 m)
Now start...
With range hood in kitchen.
Slide cardboard or hardboard under
range before moving range across
floor to prevent damaging floor
covering.
Cover countertop, cooktop or set-in
range with a thick, protective covering
to prevent damaging them.
1.
Disconnect and move
freestanding range from cabinet
opening to provide easier access
to upper cabinet and rear wall. Put
a thick, protective covering over
cooktop, set-in range or
countertop to protect from
damage or dirt.
2.
Determine which venting
method (roof or wall venting or
non-venting) you need to use. This
range hood is shipped for vented
installation.

Prepare hood

location
wood shim strips
(recessed cabinet
bottoms only)
A
A
centerline
cabinet
bottom
wall
1/8" (3.0 mm)
pilot holes
hood size
30" (76.2 cm)
13-15/16" (35.4 cm)
36" (91.4 cm)
16-15/16" (43.0 cm)
3.
Drill four 1/8" (3.0 mm) pilot
holes for hood mounting screws.
If cabinet has recessed bottom,
add wood shim strips on each
side.
10-1/2"
(26.7 cm)
1-1/2"
(3.8 cm)
A