Whirlpool RH8930XLS Kurulum Talimatları Kılavuzu - Sayfa 8
Havalandırma Davlumbazı Whirlpool RH8930XLS için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Whirlpool RH8930XLS 8 sayfaları. Vented kitchen range hood for 120 v. operation
Sayfayı Yazdır
6.
Replace
the control
circuit
board
(See Figure
2):
a.
Remove
five pin cable connector.
b.
Flip up tab on switch
flex tail connector
and remove
tail from connector.
c.
Remove
three screws
securing
board to the enclosure
and remove
board.
d.
Replace
with new circuit
board
and re-assemble
by reversing
above
procedure.
Be sure that
the switch
flex tail is inserted
far enough
into its connector
that the locking
teeth on the
connector
tab engage
the slots in the switch
tail.
i'.
If unit still does not operate,
check
membrane
switch
by removing
switch
tail from connector
and
inserting
tail of a new unattached
membraneswitch
in connector
from P. C. board sideof
hood and
secure
with tab. Insure
that tail is oriented
same as tail on attached
switch.
Operate
switch
and if
unit operates,
replace
attached
switch
with new switch.
To replace
membraneswitch,
proceed
as
follows:
a.
Release
switch
flex tail from P. C. board
connector.
b.
Remove
front
trim by removing
screws
securing
trim to hood.
Be careful
not to scratch
or
otherwise
damage
trim.
C.
Remove
switch
by carefully
running
a sharp thin knife or razor blade under edge of switch
to
break adhesive
loose at one end of switch.
Pull switch
with steady
outward
pressure.
d.
Replace
switch
by removing
paper
backing,
inserting
flex
tail
in hood
front
slot
and
CAREFULLY
aligning
switch
before
allowing
adhesive
to secure
switch
to front
panel.
Remove
switch
front protective
coating
by carefully
peeling
off of switch.
e.
Insert
flex tail into circuit
board
connector
and secure
with locking
tab.
f.
Operate
unit and if it works
properly,
replace
trim, original
circuit
board,
and circuit
board
enclosure
cover.
/- PC BOARD MfG SCREWS@)
FIVE PIN CONNECTOR
FIG. 2
P C BOARD
REMOVAL