Whirlpool UT750/IX Sağlık & Güvenlik, Kullanım & Bakım ve Kurulum Kılavuzu - Sayfa 6
Havalandırma Davlumbazı Whirlpool UT750/IX için çevrimiçi göz atın veya pdf Sağlık & Güvenlik, Kullanım & Bakım ve Kurulum Kılavuzu indirin. Whirlpool UT750/IX 22 sayfaları.
Sayfayı Yazdır
this appliance must be earthed.
Supply cord must be disconnected from power source before connection (to
the appliance).
1. Cut out an opening in the bottom of the cabinet by following the
dimensions in FIG 1 .
3. Use (2) M4 x 8 screws to install the plastic collar.
4. Lift the hood into opening and ensure locking clip is locked into
position. (locking clip is located on left side of hood body.) see FIG 2
5. Fasten (2) #6 x 1" wood screws into each short side of the hood body.
NOTE: Wood blocking may need to be added to cabinet base if
additional support is needed. see FIG 2
6. Align the front plate to the cabinet and secure the bracket to the front
side of the hood body by (2) 3/16 x 5/8 washer head screws and (2)
washers. see FIG 3
7. Install power cord and duct. Seal duct with tape (optional).
8. Turn on the hood and check for any air leaks around duct tape.
9. Install the oil cup to the center of the motor shell.
M
M
ounting
4
ethod
cabinet bottom cut-out size
wood base
locking clip
690mm
C/L
C/L
FIG 1
front view
plastic collar
controls
FIG 2
front view
plastic collar
FIG 3