Whirlpool UXT5230BDB0 Kurulum Talimatları ve Kullanım & Bakım Kılavuzu - Sayfa 6

Havalandırma Davlumbazı Whirlpool UXT5230BDB0 için çevrimiçi göz atın veya pdf Kurulum Talimatları ve Kullanım & Bakım Kılavuzu indirin. Whirlpool UXT5230BDB0 30 sayfaları. 30" (76.2 cm) and 36" (91.4 cm) range hood

Sayfayı Yazdır

INSTALLATIONINSTRUCTIONS

NOTES:

•

Depending on your model, determine which venting method

to use: roof, wall or non-vented (recirculating).

It is recommended that the vent system be installed before the

range hood is installed. Go to "Venting System" in the

"Installation Requirements" section if you need assistance.

Before making cutouts, make sure there is proper clearance

within the ceiling or wall for the vent system.

I. Disconnect

power

Electrical Shock Hazard

Disconnect

power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical

shock.

2. Mark Hole Locations

Align the exterior edge of the mounting brackets with the exterior

edges of the upper cabinet.

IMPORTANT: The brackets should touch the upper cabinet.

With a pencil, mark the upper holes on the brackets.

3. Install Brackets

•

Using a #2 Phillips screwdriver, install the drywall anchors.

•

Using #8-18 x 1" (4.2 x 25 mm) flat-head #2 Phillips screws,

install the mounting brackets using the upper holes.

NOTE: For installations to a surface other than drywall, it is

recommended

that a qualified contractor

determine the

anchoring method.

4. Prepare

Range

Hood

•

Set the range hood on its back on a covered surface.

•

Remove the filter, locking screw, and side panels.

•

Remove the rectangular damper.

•

Using a #2 Phillips screwdriver, remove the electrical box

cover.

•

Using a flat-blade screwdriver, remove the appropriate

power

supply knockout.

5. Mark Hole Locations

Lift the range hood into place and insert the mounting bracket

tabs through the slots in the back of the range hood.