Fireray 5000 Kullanıcı Kılavuzu - Sayfa 15

Duman Alarmı Fireray 5000 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Fireray 5000 17 sayfaları. Motorised infrared optical beam smoke detector

Sayfayı Yazdır
Fireray 5000 Kullanıcı Kılavuzu
20. Troubleshooting
E-00 AIM not
recognised
Detector
E-01
Communications
Error
Detector is
connected but
E-02
not 'Found'
E-03 Compensation
limit reached
Detector missed
E-04
too many
readings
Detector is not
E-05
aligned
Rapid
E-06
Obscuration Fault
Signal Too High
E-07
Fault
Compensation
E-08
Level Not Zero
during 'SET'
Signal Strength
Out of Range
E-09
when 'SET'
selected
• Refer to manufacturer for
technical assistance
• Check wiring between
System Controller and
Detector (Voltage to
Detector should be 11—
13V)
• Follow 'Find' process and
align if necessary
• Clean and realign system
• Check voltage to Controller.
• Check voltage to Detector is
>11V
• Follow alignment procedure
• Ensure clear line of sight
from Detector to Reflector
• Ensure clear line of sight
from Detector to Reflector
• Ensure there is no strong
light on Detector
• Re-align Detector using
Auto-Align
• Ensure Reflector uncovered
when 'SET' selected
• Ensure clear line of sight
from Detector to Reflector
for a radius of 0.5m
• Ensure correct distance has
been selected
• Ensure correct Reflectors
have been used
• Realign Detector
Reflector Not
Found during
E-10
Auto-Align
E-11 Auto-Align Failed
Cannot Zero
During 'S-00' in
'Set'
E-12
Signal did not
decrease when
'S-00' selected
No Signal During
'S-01' in 'Set'
E-13
Signal did not
increase when
'S-01' selected
'Centre' Stage of
Alignment Failed
Detector has
E-14
aligned on
something other
than the
Reflector
Power too low
E-21
fault
Detector not
E-24
compatible
Internal
E-26
controller fault
15
• Ensure clear line of sight
from Detector to Reflector for
a radius of 0.5m
• Ensure correct distance has
been selected
• Ensure correct Reflectors
have been used
• Realign Detector
• Ensure clear line of sight
from Detector to Reflector for
a radius of 0.5m
• Ensure correct distance has
been selected
• Ensure correct Reflectors
have been used
• Realign Detector
• Ensure Reflector was
completely covered with a
non-reflective material
• Re-align Detector using
Auto-Align
• Ensure Reflector was
uncovered when 'S-01' was
selected
• Ensure clear line of sight
from Detector to Reflector for
a radius of 0.5m
• Check power supply to
Controller
• Refer to manufacturer for
technical assistance
• Refer to manufacturer for
technical assistance