Caldwell Shootin' Gallery Montaj ve Kullanım Talimatları - Sayfa 8
Aksesuarlar Caldwell Shootin' Gallery için çevrimiçi göz atın veya pdf Montaj ve Kullanım Talimatları indirin. Caldwell Shootin' Gallery 8 sayfaları. Motorized moving target system
Sayfayı Yazdırof the Shootin' Gallery. (If not, check the battery
connections.)
5. Return to the firing line, and when it is safe to do
so, fire at the targets. As a round strikes the target, it
will tip back out of sight. As the targets return to their
starting position, they will automatically reset. Only
one shooter at a time.
WARNING: If the Shootin' Gallery stops
unexpectedly or otherwise malfunctions,
follow these steps:
1. Cease fire.
2. Make sure all weapons are unloaded with actions open.
3. When it is safe to do so, approach the Shootin' Gallery
4. Turn power switch OFF and disconnect the battery.
5. If you cannot identify and fix the problem, contact
Battenfeld Technologies, Inc. www.battenfeldtechnologies.com
Note: Your Shootin' Gallery is provided with 2 spare
fuses. Additional fuses are readily available at most
automotive stores or automotive departments.
WARNING: Use only AGC 3-Amp Fuses.
MAINTANING AND STORING YOUR
SHOOTIN' GALLERY
WARNING: Always turn power OFF and
disconnect the battery before servicing or
storing the Shootin' Gallery
Caring for the Drive System
WARNING: Turn power switch OFF and dis-
connect battery before servicing drive system.
Lubricate the chain with light-weight gear oil such as
bicycle chain oil at least twice a year, or more often if
the chain appears dry.
Chain tension is set at the factory, but you should
check it after final assembly and before each use.
Important: If the chain is too tight, it can cause prema-
ture wear and/or damage the motor.
To Check the Chain Tension:
1. Make sure that four targets are at the bottom of the
chain drive.
2. Measure the distance from Tab "A" on the target bracket
to the edge of the drive system frame "B". This measurement
1 / 2
should be between
" and
(Photo R)
5 / 8
". Adjust as needed.
Frame B
1/2"- 5/8"
PHOTO R
To Adjust Chain Tension:
1 / 2
1. Loosen the
"-13 nut on the idler shaft.
2. Disassemble the back cover and target reaction angle.
3. Loosen the jam nut and tighten or loosen the
tension screw until chain tension is correct.
1 / 2
4. Retighten the
"-13 Nut (watch for movement as
you tighten).
5. Retighten the Jam nut.
6. Check Chain tension again and repeat the process if
further adjustment is needed.
7. Re-assemble the back cover and steel angle.
PHOTO S
Jam Nut
Tension Screw
Storing the Shootin' Gallery
Turn the power switch OFF and disconnect battery.
Store in a secure, dry location, away from children.
Ordering Replacement Parts
The Shootin' Gallery is not warrantied against
misuse, abuse, or commercial use. Should you need
a replacement part, please contact Battenfeld Technologies, Inc.,
5885 W. Van Horn Tavern Rd., Columbia, MO 65203,
573-445-9200, www.caldwellshooting.com.
Tab A
(Photo S)
1 / 4
"-20
1/2" - 13 Nut