CALECTRO UG-7-A6O-24V Kurulum ve Bakım Kılavuzu - Sayfa 4

Duman Alarmı CALECTRO UG-7-A6O-24V için çevrimiçi göz atın veya pdf Kurulum ve Bakım Kılavuzu indirin. CALECTRO UG-7-A6O-24V 12 sayfaları.

Figure 2

Mounting position

Air flow

direction

We recommend that the UG-7-A6O is mounted on a distance of approximately 3 times the duct diameter before

an obstruction such as dampers, filters or bends, and approximately 5 times the diameter after these obstructions

as shown in Figure 3.

Figure 3

[5.2] MOUNTING OF DETECTOR ON THE DUCT



Drill a 1 ½ inch (38 mm) hole where the detector is to be mounted.



Measure the diameter of the duct.



The sampling tube should penetrate approximately 90% of the width of the duct. See Section 4 Table

4.1.



If necessary, shorten the sampling tube and insert the end plug. Figure 5.

NOTE: When installing sampling tubes longer than 2 ft. see Section 5.4



Insert the sampling tube in the Base Part. Figure 6.



Secure the sampling tube by fastening the screw. Figure 7.



Insert the sampling tube in the duct and secure the UG-7-A6O to the duct using the three provided

metal screws (Arrows 1,2 and 3). Figure 8.

Figure 5

Do not cut this end

UG-7-A6O Installation manual

HFE716 Version: 14

Ventilation duct

End plug

page 4

Date: 2014-03-24