Firetide FWB-100 Kullanıcı Kılavuzu - Sayfa 4

Kablosuz Erişim Noktası Firetide FWB-100 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Firetide FWB-100 13 sayfaları. Wireless bridge

Sayfayı Yazdır

Chapter 2. Configuring the FWB-100

Initial Setup & login

Operating Country

Firetide FWB-100 Wireless Bridge User Guide

Firetide FWB units are shipped in pairs, and must be configured prior to deployment in the field.

Set the two units up on the bench and apply power. Wait about 1-2 minutes for the units to boot

up and establish a radio connection.

Each unit has a label, as shown below, which identifies the unit and its partner (see highlighted

area). Connect your computer to the power insertion unit which feeds the lower-numbered member

of the pair.

Firetide Wireless Bridge

(FWB)

0980

FCC ID: REP-4200

IC ID: 4988A-4200

This device complies with Part 15 of the FCC

Rules. Operation is subject to the following

two conditions:

(1) This device may not cause harmful

interference, and (2) This device must accept

any inter ference received, including

interference that may cause undesired

operation.

Input Power: 48 VDC POE, 0.25 A

Made in China

Warranty Void if Opened

S/N

MO 3 2 4 0 8 0 6 0 0 0 1 6 7

Paired

with

MO 3 2 4 0 8 0 6 0 0 0 3 9 1

FWB nodes are paired, or "married", at the factory. Within each pair, the unit with the lower serial

number is assigned IP address 192.168.224.161, and the unit with the higher serial number is as-

signed IP address 192.168.224.162. You can change these addresses if desired.

Configure the computer to have an IP address on the subnet 192.168.224.0/24. When you power

up the two units on the bench, they will usually connect. If they do, connect to the unit labeled

with the 192.168.224.161 IP address. Point the browser at https://192.168.224.161. You will be

asked for a login and password; the defaults are admin and firetide. You should change these when

you configure the FWB units. Proceed to set the country code.

If the two nodes did not connect with each other, you must point your browser at the second node,

at https://192.168.224.162. Log in as above, and set its country code.

Firetide FWB-100 nodes require that you enter the country of operation to ensure compliance

with the channel limitations, indoor/outdoor restrictions, and license requirements of your region.

Selecting a country other than where you are using the device may result in illegal operation and

may cause harmful interference to other systems. The node will reboot after clicking Apply to set

the country code.

Antenna

Polarity

192.168.224.161

192.168.224.162

August 2010