Acoms Technisport 2.4G Kullanım Kılavuzu - Sayfa 13

Uzaktan Kumanda Acoms Technisport 2.4G için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Acoms Technisport 2.4G 14 sayfaları.

Electrical character for 24GHz and attenUon

. As 2.4GHz is very high frequency, the product will not be effected bV

motor noise.

However, the electrical wave characteristic is very different from

lower frequency.

lf there are any metal parts or carbon between TX antenna and RX

antenna, the electrical wave can become weak and it is easy to

experience interference. lf RX antenna is covered by metal or carbon,

please change lhe installing position.

Besides, il the partition of the driving course is the metal, when vou

drive your car at lower place, lhe electrical wave sometimes become

hard to reach.

. 2.4GHz electrical waves are sometimes easily reflected by metal parts.

lf you find transmitter operation become slow at the track, Dlease

move your drivtng position Please also check if the receiver is installed

properly.

. When you drive the car, please switch the transmitter on after vou are

at the driving position.

. lf you have interference, stop the car and switch the transmitter otf

once, then switch on again. The transmitter will scan for a new bano

and fix on it.

. More than 3.5V operation voltage is necessary for the receiver.

Especially for an Electrical Powered car, In case of low voltage the

receiver may reset itself.

lf you are usrng 4 or 5 cell power battery tt is highly recommended to

install another power source for the receiver.

. When you operate the transmitter atter you install the servo on the car,

if LED brightness of the recerver ts changed, this indicates that the

receaver voltage has become low.

In this case, please change the power source of the receiver.

1 2