Firetide HotPoint 5100 Donanım Kurulum Kılavuzu - Sayfa 14
Kablosuz Erişim Noktası Firetide HotPoint 5100 için çevrimiçi göz atın veya pdf Donanım Kurulum Kılavuzu indirin. Firetide HotPoint 5100 19 sayfaları.
Ayrıca Firetide HotPoint 5100 için: Manuel (2 sayfalar)
Sayfayı Yazdır
HotPoint 5100 access point preparation
LEDs
LED boot operation
LED operation during client association and data traffic
LED operation during a firmware upgrade
Radios
8 HotPoint 5100 Access Point Hardware Installation Guide
HotPoint 5100 access points have three LEDs:
• Power
• 2.4GHz radio
• 5GHz radio
During boot up, LEDs operate in this order:
1. All LEDs come on for 5 seconds.
2. The 5GHz radio LED goes off.
3. The 5GHz radio LED comes on again after 5 seconds. This action shows that
the LED driver started.
4. After 15 seconds, the 2.4 GHz and 5GHz radio LEDs go off. This shows that
the system is ready. The power LED stays on.
During client association and data traffic, LEDs operate this way:
• When clients associate, the appropriate radio LED comes on.
• After the LED is on, the appropriate LED blinks to indicate the date rate.
• When no clients are available, the radio LED stays off.
During a firmware upgrade, the 2.4GHz radio LED blinks quickly.
By default, Radio 1 operates in the 2.4 GHz band, and Radio 2 operates in the 5
GHz band.