Alcolock V3 Series B2 12V ECU Servis Kılavuzu - Sayfa 3

Test Ekipmanları Alcolock V3 Series B2 12V ECU için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Alcolock V3 Series B2 12V ECU 8 sayfaları.

GENERAL INSpECTION

• Visually inspect the handset. No damaged ordisconnected parts should be present.

• Check that none of the labels on the handset are loose.

• Check the cables for any cuts or nicks, also check thatthe cable connectors are not exposed.

• Check that the mouthpiece insertion area of the handsetis free of debris, dirt or contaminants.

• Maintenance of the unit is insured through calibration. Please refer to the calibration

procedures section of this guide for step by step instructions to calibrate the unit.

• V3's are made for field use, making them susceptible todirt and debris. The handset should be

cleaned with adamp cloth and mild soap. Do not use abrasive cleaners or solvents on the unit.

GENERAL FUNCTIONAL TEST

The following are some actions to test the functionality of the interlock system.

To test that all inputs to the V3 are off, and that both pushbuttons are working: if the handset is

awake, hold both pushbuttons for 3 seconds. The handset should go to the lower power state, the

display and all the LEDs should turn off.

Alcolock

disabled

OK to start engine

Activate(hold)

Start motor

Cancel(hold)

disabled

Alcolock

disabled

OK to start engine

Activate(hold)

To test the display, backlights and left pushbutton: Wake the handset

up by pressing the left pushbutton. The display should show, "Alcolock

disabled, OK to start engine".

To test the ignition input: turn the ignition to the ON position, the display

should show "Start motor". The status LED should be green, and a

series of tones should be heard.

To test the engine run input, and the green status LED: start the motor

of the vehicle, the display should show "disabled" and the status LED

should be green

To test the right pushbutton: turn off the ignition and hold the right

pushbutton for 3 seconds. The display should show, "Alcolock

disabled, OK to start engine."