3Com FDDI SMF Kurulum Kılavuzu - Sayfa 4

Ağ Donanımı 3Com FDDI SMF için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. 3Com FDDI SMF 8 sayfaları.

Sayfayı Yazdır

FDDI M

ODULE

NSTALLATION

Before You Install

Read before

installing in an

empty slot

UIDE

IEC 825, Class 1 LED devices are for connection only to Class 1 LED

devices. Multimode ﬁber-optic interfaces use LEDs. IEC 825, Class 1 laser

devices are for connection only to Class 1 laser devices. Single-mode

ﬁber-optic interfaces use lasers.

LED PRODUCT

Before you install your new module, follow the appropriate preinstallation

instructions in this section, depending on whether you are installing the

initial FDDI module or replacing one.

CAUTION: The FDDI module requires release 2.0.0 or higher of the

CoreBuilder 3500 system software.

Your system is shipped with no modules installed and with protective

faceplates covering the installation slots. Before you install the module,

remove the protective faceplate that covers the selected installation slot.

To remove a faceplate:

1 Loosen the two captive screws that secure the faceplate to the chassis.

2 Move the injector/ejector handles to the outward position.

3 Pull the faceplate away from the system. See Figure 2.

Figure 2 Removing the Faceplate

PWR

RUN

Injector/Ejector handle

CLASS 1

PCMCIA

ERROR

SYS

INS

PS1

PS2

FAN

TEMP SERVICE

Captive screw

CLASS 1

LASER PRODUCT

ETHERNET

MODEM

TERMINAL

10BT

INS

Faceplate