3Com H3C S3100 16C SI Manuel - Sayfa 2

Ağ Donanımı 3Com H3C S3100 16C SI için çevrimiçi göz atın veya pdf Manuel indirin. 3Com H3C S3100 16C SI 11 sayfaları. Loopback detection feature manual

Sayfayı Yazdır
H3C Loopback Detection Feature Manual
Release 2107

Chapter 1 Loopback Detection Configuration

Note:
Two functions are added to release 2107: configuring loopback detection for a list of
ports in bulk, and enabling auto-shutdown of loopback ports.

1.1 Loopback Detection Configuration

1.1.1 Loopback Detection Overview

Loopback detection is used to monitor if a port of a switch is looped back.
After you enable loopback detection on Ethernet ports, the switch can monitor if an
external loopback occurs on them. If there is a loopback port found, the switch will deal
with the loopback port according to your configuration.
1)
If a loop is found on an access port, the system will set the port to the block state
(ports in this state cannot forward data packets), send log messages to the
terminal, and remove the corresponding MAC forwarding entry.
If you have additionally enabled the loopback port auto-shutdown function on the
port, the system will shut down the port, and send log messages to the terminal.
After the loop is removed, you need to use the undo shutdown command to bring
up the port.
If you have not enabled the loopback port auto-shutdown function on the port, the
port will automatically resume the normal forwarding state after the loop is
removed.
2)
If a loop is found on a trunk or hybrid port, the system sends log messages to the
terminal. If you have additionally enabled the loopback port control function or the
loopback port auto-shutdown function, the system will deal with the port
accordingly:
If the loopback port control function is enabled on the port, the system will set the
port to the block state (ports in this state cannot forward data packets), send log
messages to the terminal, and remove the corresponding MAC forwarding entry.
After the loop is removed, the port will automatically resume the normal forwarding
state.
Chapter 1 Loopback Detection Configuration
1-1