Alcorn Mcbride DMX OverRide Kullanıcı Kılavuzu - Sayfa 6

Kontrol Sistemleri Alcorn Mcbride DMX OverRide için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Alcorn Mcbride DMX OverRide 12 sayfaları.

Rear Panel

The rear panel of the DMX OverRide includes the DMX Input and Output connectors,

the configuration DIP switches, and the Power connector.

Power Connector

DMX

Configuration Configuration

If possible, it's a good thing to make sure the rear-panel DIP switches are set the way you

want before installing into the rack. The DMX OverRide rear panel contains two banks

of DIP switches. In many cases, you can leave these switches in their factory-default

positions, but if you need to change anything here's how each switch works.

Left DIP Switch Bank - DMX Configuration

Position

Front Panel Lock – Turn ON to disable the Front Panel Scene Buttons.

Power Loss Detect – Turn ON to cause the unit to go to Scene 2 upon power

failure. The Scene 2 look will remain when power is restored.

Battery Enable – Enables the internal battery.

Record Enable – Turn this switch ON to record DMX Scenes 1, 2, and 3.

DMX Dropout Recovery Enable – If this switch is ON, Scene 1 is

automatically activated if DMX drops out while in Resume mode.

DMX Dropout Auto Resume Mode – The unit will automatically return to

Resume mode once DMX is restored if this switch is ON. When this switch is

OFF, a Channel #512 value sequence input from the lighting controller of 0%

- 75% - 25% - 100%, followed by any value other than 100% on Channel

#512 will cause a return to Resume mode (see note on Resume Code Feature).

DMX Dropout Delay – Turning ON this switch will cause the unit to ignore

DMX dropouts shorter than approximately one second and delay the automatic

switch to Scene 1 when the Dropout Recovery Enable switch is ON.

Termination - This switch enables the 110-ohm DMX input termination.

Input

Remote Input

Connections

Function (ON = Down)

DMX In

DMX Out